ISL8484IUZ-T

DUAL Analog Switches BREAK-BEFORE-MAKE 10 Pins 3V MSOP

Manufacturer: Intersil (Renesas Electronics America)
Nocochips NO: 391-ISL8484IUZ-T
Package: MSOP
Datasheet: PDF
Stock: 441
Description: DUAL Analog Switches BREAK-BEFORE-MAKE 10 Pins 3V MSOP(Kg)

Details

Tags

Parameters
Factory Lead Time	1 Week
Mount	Surface Mount
Package / Case	MSOP
Number of Pins	10
Packaging	Tape & Reel
Published	2001
JESD-609 Code	e3
Part Status	Active
Moisture Sensitivity Level (MSL)	2
Number of Terminations	10
Resistance	500mOhm
Terminal Finish	Matte Tin (Sn) - annealed
Max Operating Temperature	85°C
Min Operating Temperature	-40°C
Subcategory	Multiplexer or Switches
Technology	CMOS
Terminal Position	DUAL
Terminal Form	GULL WING
Peak Reflow Temperature (Cel)	260
Number of Functions	2
Supply Voltage	3V
Terminal Pitch	0.5mm
Time@Peak Reflow Temperature-Max (s)	30
Output	SEPARATE OUTPUT
Pin Count	10
Power Supplies	1.8/4.3V
Temperature Grade	INDUSTRIAL
Number of Channels	1
Max Supply Voltage	4.5V
Min Supply Voltage	1.65V
Operating Supply Current	100nA
Max Supply Current	100nA
Number of Bits	2
Throw Configuration	SPDT
Turn On Delay Time	40 ns
Supply Type	Single
Turn-Off Delay Time	20 ns
Off-state Isolation-Nom	68 dB
On-state Resistance Match-Nom	0.03Ohm
Switching	BREAK-BEFORE-MAKE
Switch-on Time-Max	30ns
Height Seated (Max)	1.1mm
Length	3mm
Width	3mm
Radiation Hardening	No
RoHS Status	RoHS Compliant
Lead Free	Lead Free

ISL8484IUZ-T Overview

Presented in MSOP, this electrical component is convenient for overseas shipping. This packaging method provides high reliability because it uses advanced packaging techniques. Totally, there are 10 terminations. A high-quality output is provided by the electrical component's 1 channels. An 3V voltage supply should allow the electrical part to be turned on and run. There are 10 pins injected into the electronic part body. Internally, this switch multiplexer has a resistance of 500mOhm. For details about the functions of 10 pins, please refer to the datasheets. The analog multiplexer shown here is a typical Multiplexer or Switches. normally, users should not supply switches with voltages higher than 4.5V. Analog switch ics with Single supply type are cost-effective. It is recommended that the electrical component receives a voltage of 1.65V. For this digital switch to work, 100nA current would suffice. If put voltage greater than 100nA on the device, damage may be caused to the analogue multiplexer. This analog switch ic utilizes SEPARATE OUTPUT output. An environment with a temperature greater than 85°C should not be used to operate the digital switches. It is able to conduct in a 2-bit way.