ISL8499IRTZ
| Parameters | |
|---|---|
| Factory Lead Time | 1 Week |
| Mount | Surface Mount |
| Package / Case | QFN |
| Number of Pins | 16 |
| Published | 2001 |
| JESD-609 Code | e3 |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 2 |
| Number of Terminations | 16 |
| Resistance | 250mOhm |
| Terminal Finish | Matte Tin (Sn) - annealed |
| Max Operating Temperature | 85°C |
| Min Operating Temperature | -40°C |
| HTS Code | 8542.39.00.01 |
| Subcategory | Multiplexer or Switches |
| Technology | CMOS |
| Terminal Position | QUAD |
| Peak Reflow Temperature (Cel) | 260 |
| Number of Functions | 4 |
| Supply Voltage | 1.8V |
| Terminal Pitch | 0.5mm |
| Time@Peak Reflow Temperature-Max (s) | 30 |
| Output | SEPARATE OUTPUT |
| Power Supplies | 1.8/4.3V |
| Temperature Grade | INDUSTRIAL |
| Number of Channels | 1 |
| Max Supply Voltage | 4.5V |
| Min Supply Voltage | 1.65V |
| Operating Supply Current | 90nA |
| Max Supply Current | 90nA |
| Throw Configuration | SPDT |
| Turn On Delay Time | 30 ns |
| Supply Type | Single |
| Turn-Off Delay Time | 27 ns |
| Off-state Isolation-Nom | 68 dB |
| On-state Resistance Match-Nom | 0.04Ohm |
| Switching | BREAK-BEFORE-MAKE |
| Switch-on Time-Max | 65ns |
| Switch-off Time-Max | 58ns |
| Height Seated (Max) | 0.8mm |
| Length | 3mm |
| Width | 3mm |
| Radiation Hardening | No |
| RoHS Status | RoHS Compliant |
ISL8499IRTZ Overview
As the electronic part is packed in QFN, international shipping is convenient. Totally, there are 16 terminations. This electronic part offers high-quality output due to its 1 channels. When the electronic component is given a voltage of 1.8V, it should be turned on and run. It has an internal resistance of 250mOhm. To find out what the functions of 16 pins are, please refer to their datasheets. There is a standard Multiplexer or Switches analogue multiplexer here. normally, users should not supply switches with voltages higher than 4.5V. Analogue multiplexers of the Single supply type that are cost-effective. 1.65V is the lowest voltage the electrical component should receive. An operating current of 90nA would be sufficient for this switch device. Put voltage above 90nA on the multiplexer to cause damage. The analog switch ic utilizes SEPARATE OUTPUT outputs in total. An environment with a temperature greater than 85°C should not be used to operate the digital switches.
ISL8499IRTZ Features
1 Channels
90nA Supply Current
ISL8499IRTZ Applications
There are a lot of Intersil (Renesas Electronics America) ISL8499IRTZ Analog Switches & Multiplexers ICs applications.
- Cell phones
- Fiber In The Loop (FITL)
- Communication systems
- Channelized and Unchannelized DS3 applications
- Audio signal routing
- E1 Network Equipment
- Cable Telephony – NIU, Set-Top Box, Home Side Box
- Communication systems
- Existing multiplexer applications (both fault-protected and nonfault-protected)
- ISDN NT1/TA
