ISL8499IRZ
| Parameters | |
|---|---|
| Factory Lead Time | 1 Week |
| Mount | Surface Mount |
| Package / Case | QFN |
| Number of Pins | 16 |
| Packaging | Bulk |
| Published | 2001 |
| JESD-609 Code | e3 |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 2 |
| Number of Terminations | 16 |
| Resistance | 250mOhm |
| Terminal Finish | Matte Tin (Sn) - annealed |
| Max Operating Temperature | 85°C |
| Min Operating Temperature | -40°C |
| Subcategory | Multiplexer or Switches |
| Technology | CMOS |
| Terminal Position | QUAD |
| Peak Reflow Temperature (Cel) | 260 |
| Number of Functions | 4 |
| Supply Voltage | 1.8V |
| Terminal Pitch | 0.5mm |
| Time@Peak Reflow Temperature-Max (s) | 30 |
| Output | SEPARATE OUTPUT |
| Temperature Grade | INDUSTRIAL |
| Number of Channels | 1 |
| Max Supply Voltage | 4.5V |
| Min Supply Voltage | 1.65V |
| Operating Supply Current | 90nA |
| Max Supply Current | 90nA |
| Number of Bits | 4 |
| Throw Configuration | SPDT |
| Turn On Delay Time | 30 ns |
| Supply Type | Single |
| Bandwidth | 104MHz |
| Turn-Off Delay Time | 27 ns |
| Off-state Isolation-Nom | 68 dB |
| On-state Resistance Match-Nom | 0.04Ohm |
| Switching | BREAK-BEFORE-MAKE |
| Switch-on Time-Max | 65ns |
| Switch-off Time-Max | 58ns |
| Height Seated (Max) | 1mm |
| Length | 3mm |
| Radiation Hardening | No |
| RoHS Status | RoHS Compliant |
| Lead Free | Lead Free |
ISL8499IRZ Overview
The electrical component comes in QFN packaging, which makes it convenient to ship overseas. A high level of reliability can be achieved through the use of an advanced packaging method Bulk. The total number of terminations is 16. A electrical component with 1 channels is capable of high-quality output. If the voltage supply is 1.8V volts, the electrical component should be turned on and run. It has an internal resistance of 250mOhm. Datasheets for 16 pin functions are available upon request. Multiplexer or Switches is a typical switch device. normally, users should not supply switches with voltages higher than 4.5V. Analogue multiplexer with a Single supply type that is cost-effective. It is recommended that the electrical component receives a voltage of 1.65V. The analogue multiplexer could operate on 90nA current. A voltage higher than 90nA may cause damage to the switch multiplexer. It is possible to use SEPARATE OUTPUT outputs on this digital multiplexer. A 104MHz-bandwidth can be used for data transfer. An environment with a temperature greater than 85°C should not be used to operate the digital switches. The switch device is capable of conducting in a 4-bit mode.
ISL8499IRZ Features
1 Channels
90nA Supply Current
Bandwidth: 104MHz
4-Bit
ISL8499IRZ Applications
There are a lot of Intersil (Renesas Electronics America) ISL8499IRZ Analog Switches & Multiplexers ICs applications.
- Cell phones
- Audio and video routing
- CSU
- DSUs
- Wireless Local Loop
- Cable Telephony – NIU, Set-Top Box, Home Side Box
- E1 Network Equipment
- Battery Powered Instruments
- FTTH
- Mechanical reed relay replacement
