IXMS150PSI
| Parameters | |
|---|---|
| Topology | Half-Bridge |
| Frequency - Switching | 10kHz~400kHz |
| Supply Current-Max (Isup) | 45mA |
| Synchronous Rectifier | No |
| Duty Cycle (Max) | 95% |
| RoHS Status | RoHS Compliant |
| Lead Free | Contains Lead |
| Mounting Type | Through Hole |
| Package / Case | 24-DIP (0.300, 7.62mm) |
| Surface Mount | NO |
| Operating Temperature | -40°C~85°C TA |
| Packaging | Tube |
| Published | 1998 |
| Pbfree Code | yes |
| Part Status | Obsolete |
| Moisture Sensitivity Level (MSL) | Not Applicable |
| Number of Terminations | 24 |
| ECCN Code | EAR99 |
| Technology | CMOS |
| Terminal Position | DUAL |
| Supply Voltage | 12V |
| Frequency | 400kHz |
| Base Part Number | IXMS150 |
| Function | Step-Up/Step-Down |
| Number of Outputs | 2 |
| Output Type | Transistor Driver |
| Supply Voltage-Min (Vsup) | 10.8V |
| Analog IC - Other Type | STEPPER MOTOR CONTROLLER |
| Output Configuration | Positive |
| Output Current | 10mA |
| Voltage - Supply (Vcc/Vdd) | 12V |
| Control Features | Dead Time Control, Enable, Frequency Control |
IXMS150PSI Overview
Capsuled in the 24-DIP (0.300, 7.62mm) package, the switching controller can be used for a wide range of applications. For outputs of 2, this dc motor controller is suitable. Tube solid enclosure protects the pmic. Transistor Driver dc switching's outputs (s) are supported. dc control's supply and operating voltages are 12V. Suitable for work in a -40°C~85°C TA dc switcher. The switching controller can be switched at 10kHz~400kHz. The Through Hole value makes it suitable for general dc dc regulator. DCDC regulator is controlled efficiently by Dead Time Control, Enable, Frequency Control. An analog IC with the STEPPER MOTOR CONTROLLER signal is connected to the switch converters. There are a terminal (s) on the switching converters that are designed at DUAL. 24 terminations with a variety of function. IXMS150 can be used to locate other relevant dc to dc converter ics. If you start a project, note down the dc dc regulator's usual output current of 10mA. There is 400kHz frequency setting on the switching controller. The supply voltage must be 12V. It is important that the controller is supplied with 45mA more than 45mA volts of current.
IXMS150PSI Features
Transistor Driver Outputs
Switching Frequency: 10kHz~400kHz
Dead Time Control, Enable, Frequency Control
Frequency: 400kHz
IXMS150PSI Applications
There are a lot of IXYS IXMS150PSI DC to DC converter applications.
- Printing equipment
- Wind power
- Packaging
- Correction machines
- Game consoles
- seismic instrument power circuits
- Direct power supply system
- Energy management systems
- Low output voltage switching power supply circuits
- Electric water heaters
