JL148SCA
| Parameters | |
|---|---|
| Lifecycle Status | ACTIVE (Last Updated: 4 days ago) |
| Package / Case | CDIP |
| Surface Mount | NO |
| Number of Pins | 14 |
| Moisture Sensitivity Level (MSL) | 1 |
| Number of Terminations | 14 |
| ECCN Code | EAR99 |
| Max Operating Temperature | 125°C |
| Min Operating Temperature | -55°C |
| Subcategory | Operational Amplifier |
| Packing Method | TUBE |
| Technology | BIPOLAR |
| Terminal Position | DUAL |
| Terminal Form | THROUGH-HOLE |
| Peak Reflow Temperature (Cel) | NOT SPECIFIED |
| Number of Functions | 4 |
| Supply Voltage | 20V |
| Reach Compliance Code | not_compliant |
| Time@Peak Reflow Temperature-Max (s) | NOT SPECIFIED |
| Pin Count | 14 |
| Qualification Status | Not Qualified |
| Operating Supply Voltage | 22V |
| Power Supplies | +-20V |
| Temperature Grade | MILITARY |
| Number of Channels | 4 |
| Nominal Supply Current | 3.6mA |
| Current - Output | 75mA |
| Slew Rate | 0.2 V/μs |
| Architecture | VOLTAGE-FEEDBACK |
| Amplifier Type | OPERATIONAL AMPLIFIER |
| Common Mode Rejection Ratio | 76 dB |
| Current - Input Bias | 100nA |
| Input Offset Voltage (Vos) | 6mV |
| Gain Bandwidth Product | 1MHz |
| Neg Supply Voltage-Nom (Vsup) | -20V |
| Unity Gain BW-Nom | 1000 kHz |
| Voltage Gain | 80dB |
| Average Bias Current-Max (IIB) | 0.1μA |
| Low-Offset | NO |
| Frequency Compensation | YES |
| Max Dual Supply Voltage | 22V |
| Low-Bias | NO |
| Micropower | YES |
| Min Dual Supply Voltage | 5V |
| Bias Current-Max (IIB) @25C | 0.1μA |
| Programmable Power | NO |
| Screening Level | MIL-STD-883 |
| Wideband | NO |
| Power | NO |
| Input Offset Current-Max (IIO) | 0.025μA |
| Height | 5.08mm |
| Length | 19.56mm |
| Width | 6.67mm |
| Thickness | 4.57mm |
| RoHS Status | Non-RoHS Compliant |
| Lead Free | Contains Lead |
JL148SCA Overview
There is a CDIP case in which the instrumentation amplifier is packaged. Op amps are OPERATIONAL AMPLIFIER types of amplifier on the chip. A total of 14 terminations have been reported in the past few weeks. The total number of pins on linear amplifier is 14. Please take in mind that this instrumentation amplifier should be run at 20V. Instrumentation amplifier is a part of Operational Amplifier. An 14-pin op amp ic is included in the package. In terms of the input offset voltage, instrumentation amplifier rates at 6mV. Voltage gain should remain at 80dB. 4 channels are available on the instrumentation amplifier. To operate this buffer amplifier, the temperature must not be lower than -55°C. A temperature greater than 125°C should not be used for the operation of this instrumentation amplifier. The operating supply voltage of instrumentation amplifier is rated 22V voltage. For the packing of the instrumentation amplifier, TUBE is adopted. The dual supply voltage of 22V should be used for the conduct of this electronic component.
JL148SCA Features
14 Pins
supply voltage of 20V
80dB voltage gain
JL148SCA Applications
There are a lot of Texas Instruments JL148SCA Instrumentational OP Amps applications.
- Fast A/D and D/A converters
- Signal operation
- Commercial audio systems
- Communication device
- Ultrasound transducers
- Home audio systems
- Video amplifiers
- Precision measurement
- Power transmission
- Micro signal measurement
