Parameters |
Lifecycle Status |
ACTIVE (Last Updated: 1 day ago) |
Mount |
Surface Mount |
Number of Pins |
10 |
Moisture Sensitivity Level (MSL) |
1 |
Number of Terminations |
10 |
ECCN Code |
EAR99 |
Max Operating Temperature |
125°C |
Min Operating Temperature |
-55°C |
Subcategory |
Comparator |
Technology |
BIPOLAR |
Terminal Position |
DUAL |
Terminal Form |
GULL WING |
Peak Reflow Temperature (Cel) |
NOT SPECIFIED |
Number of Functions |
2 |
Supply Voltage |
15V |
Time@Peak Reflow Temperature-Max (s) |
NOT SPECIFIED |
Pin Count |
10 |
Qualification Status |
Not Qualified |
Output Type |
OPEN-COLLECTOR |
Temperature Grade |
MILITARY |
Number of Channels |
2 |
Max Supply Voltage |
36V |
Min Supply Voltage |
5V |
Power Dissipation-Max |
500mW |
Nominal Supply Current |
11mA |
Max Supply Current |
4.2mA |
Current - Output |
25mA |
Response Time |
80 ns |
Amplifier Type |
COMPARATOR |
Common Mode Rejection Ratio |
80 dB |
Current - Input Bias |
475nA |
Input Offset Voltage (Vos) |
3.8mV |
Neg Supply Voltage-Nom (Vsup) |
-15V |
Average Bias Current-Max (IIB) |
0.5μA |
Max Dual Supply Voltage |
18V |
Min Dual Supply Voltage |
2.5V |
Bias Current-Max (IIB) @25C |
0.5μA |
Height |
2.34mm |
Length |
6.858mm |
Width |
6.121mm |
Thickness |
1.778mm |
Radiation Hardening |
Yes |
RoHS Status |
RoHS Compliant |
Lead Free |
Contains Lead |
LM119WGRQMLV Overview
Op amps are COMPARATOR types of amplifier on the chip. The number of terminations is approaching the 10 mark. A total of 10 pins are located on this board. It is important to remember that this op amp should be operated at a voltage of 15V volts. There are two types of Comparator op amps in this case, and this device falls into one of them. 10 pins are included on the operational amplifiers. In terms of the input offset voltage, instrumentation amplifier rates at 3.8mV. Buffer op amp is equipped with 2 channels on the device. There are more than a few advantages to using this instrumentation amplifier, one of which is that it outputs OPEN-COLLECTOR signals. For the buffer op amp to operate properly, it must be above the temperature of -55°C degrees Celsius. A temperature greater than 125°C should not be used for the operation of buffer amplifier. With regard tp supply voltage, op amp is used under 36V. Keeping the linear amplifier's supply voltage above 5V is recommended. Conduct linear amplifier under the dual suuply voltage of 18V.
LM119WGRQMLV Features
10 Pins
supply voltage of 15V
Output Type: OPEN-COLLECTOR
LM119WGRQMLV Applications
There are a lot of Texas Instruments LM119WGRQMLV Instrumentational OP Amps applications.
- Addition operation circuits
- Power transmission
- Commercial audio systems
- Industrial control system
- Precision measurement
- Weak signal detection
- Hand-held batteries
- Radar
- Proportional operation circuits
- Portable media players