LM139AWG/883
| Parameters | |
|---|---|
| Lifecycle Status | ACTIVE (Last Updated: 2 days ago) |
| Mount | Surface Mount |
| Number of Pins | 14 |
| JESD-609 Code | e0 |
| Moisture Sensitivity Level (MSL) | 1 |
| Number of Terminations | 14 |
| ECCN Code | EAR99 |
| Terminal Finish | Tin/Lead (Sn/Pb) |
| Max Operating Temperature | 125°C |
| Min Operating Temperature | -55°C |
| Subcategory | Comparator |
| Technology | BIPOLAR |
| Terminal Position | DUAL |
| Terminal Form | GULL WING |
| Number of Functions | 4 |
| Supply Voltage | 5V |
| Terminal Pitch | 1.27mm |
| Pin Count | 14 |
| Output Type | OPEN-COLLECTOR |
| Power Supplies | 5V |
| Temperature Grade | MILITARY |
| Number of Channels | 4 |
| Max Supply Voltage | 30V |
| Min Supply Voltage | 5V |
| Nominal Supply Current | 2mA |
| Power Dissipation | 680mW |
| Current - Output | 16mA |
| Response Time | 5 μs |
| Amplifier Type | COMPARATOR |
| Common Mode Rejection Ratio | 60 dB |
| Current - Input Bias | 1nA |
| Input Offset Voltage (Vos) | 2mV |
| Voltage Gain | 93.98dB |
| Average Bias Current-Max (IIB) | 0.1μA |
| Power Supply Rejection Ratio (PSRR) | 60dB |
| Max Dual Supply Voltage | 15V |
| Min Dual Supply Voltage | 2.5V |
| Bias Current-Max (IIB) @25C | 0.015μA |
| Screening Level | MIL-STD-883 |
| Height | 2.34mm |
| Length | 9.906mm |
| Width | 6.35mm |
| Thickness | 1.778mm |
| Radiation Hardening | No |
| RoHS Status | RoHS Compliant |
| Lead Free | Contains Lead |
LM139AWG/883 Overview
Buffer amps of this type are called COMPARATOR-types. It is estimated that there will be 14 terminations in the next few months. In total, there are 14 pins on this op amp ic. It would be helpful if you could remember that this op amp ic should be powered by an 5V battery. In order to be more specific, this instrumentation amplifier is one of the types of Comparator devices. The buffer op amp includes 14 pins. In terms of input offset voltage, operational amplifier rates 2mV. There should be no change in the voltage gain. There are 4 channels on the operational amplifiers. One of the many benefits of this op amp ic is that it emits OPEN-COLLECTOR signals. It is recommended that the temperature of this op amp ic should not fall below -55°C degrees Fahrenheit at any time. A temperature greater than 125°C should not be used for the operation of buffer amplifier. With regard tp supply voltage, op amp is used under 30V. Keeping the linear amplifier's supply voltage above 5V is recommended. As a general rule, you should conduct this electronic component under dual supply voltages of 15V volts.
LM139AWG/883 Features
14 Pins
supply voltage of 5V
93.98dB voltage gain
Output Type: OPEN-COLLECTOR
LM139AWG/883 Applications
There are a lot of Texas Instruments LM139AWG/883 Instrumentational OP Amps applications.
- Signal operation
- Wireless base stations
- Multiplication circuits
- Precision measurement
- Weak signal detection
- Micro signal measurement
- Professional videography
- Switching amplifier
- Portable docking station
- Voltage regulation circuit
