LM7321MF
| Parameters | |
|---|---|
| Mount | Surface Mount |
| Package / Case | SOT-23 |
| Number of Pins | 5 |
| Packaging | Cut Tape |
| JESD-609 Code | e0 |
| Moisture Sensitivity Level (MSL) | 1 |
| Number of Terminations | 5 |
| ECCN Code | EAR99 |
| Max Operating Temperature | 125°C |
| Min Operating Temperature | -40°C |
| Subcategory | Operational Amplifier |
| Terminal Position | DUAL |
| Terminal Form | GULL WING |
| Number of Functions | 1 |
| Supply Voltage | 5V |
| Pin Count | 5 |
| Qualification Status | Not Qualified |
| Number of Elements | 1 |
| Temperature Grade | AUTOMOTIVE |
| Max Supply Voltage | 32V |
| Min Supply Voltage | 2.5V |
| Current - Output | 60mA |
| Slew Rate | 18 V/μs |
| Amplifier Type | OPERATIONAL AMPLIFIER |
| Common Mode Rejection Ratio | 65 dB |
| Current - Input Bias | 1.2μA |
| Input Offset Voltage (Vos) | 5mV |
| Bandwidth | 20MHz |
| Gain Bandwidth Product | 16MHz |
| Neg Supply Voltage-Nom (Vsup) | -5V |
| Unity Gain BW-Nom | 16000 kHz |
| Voltage Gain | 80dB |
| Power Supply Rejection Ratio (PSRR) | 78dB |
| Max Dual Supply Voltage | 16V |
| Min Dual Supply Voltage | 1.25V |
| Length | 2.92mm |
| REACH SVHC | No SVHC |
| RoHS Status | RoHS Compliant |
LM7321MF Overview
There is a SOT-23 case package that contains the instrumentation amplifiers. An op amp ic of the OPERATIONAL AMPLIFIER type. As far as the packaging is concerned, buffer op amp is delivered in a Cut Tape case. There is a growing number of terminations approaching the number of 5. In total, there are 5 pins on this op amp ic. It would be helpful if you could remember that this op amp ic should be powered by an 5V battery. To be specific, this instrumentation amplifier is a type of Operational Amplifier. An 5-pin op amp ic is included in the package. Op amp ic rates 5mV for input offset voltage. It is recommended to keep the voltage gain at 80dB at all times. It should not lower than -40°C to operate buffer amplifier. A temperature greater than 125°C should not be used for the operation of this instrumentation amplifier. There are a total of 1 elements in this linear amplifier. When it comes to the voltage from which this electrical part will operate, it can operate at a maximum of less than 32V. As a general rule, it is advisable to keep the op amp's supply voltage above 2.5V at all times. There should be a dual supply voltage of 16V for you to conduct this electrical part.
LM7321MF Features
5 Pins
supply voltage of 5V
80dB voltage gain
LM7321MF Applications
There are a lot of Texas Instruments LM7321MF Instrumentational OP Amps applications.
- Subtraction operation circuits
- High speed sample
- Proportional counter tubes
- Micro signal measurement
- Portable media players
- Strain gauges
- Gaming industry
- Thermocouples
- Commercial audio systems
- Inverse/same-phase proportional circuit
