LT1013DN8#PBF
| Parameters | |
|---|---|
| Lifecycle Status | PRODUCTION (Last Updated: 2 weeks ago) |
| Package / Case | DIP |
| Number of Pins | 8 |
| Max Operating Temperature | 70°C |
| Min Operating Temperature | 0°C |
| Operating Supply Voltage | 5V |
| Number of Elements | 2 |
| Number of Channels | 2 |
| Number of Circuits | 2 |
| Max Supply Voltage | 44V |
| Min Supply Voltage | 4V |
| Operating Supply Current | 350μA |
| Slew Rate | 0.4 V/μs |
| Common Mode Rejection Ratio | 97 dB |
| Current - Input Bias | 50nA |
| Output Current per Channel | 20mA |
| Input Offset Voltage (Vos) | 40μV |
| Bandwidth | 800 kHz |
| Voltage Gain | 120dB |
| Power Supply Rejection Ratio (PSRR) | 100dB |
| Max Dual Supply Voltage | 22V |
| Min Dual Supply Voltage | 2V |
| Dual Supply Voltage | 15V |
| Nominal Gain Bandwidth Product | 800 kHz |
| Number of Amplifiers | 2 |
| Height | 3.81mm |
| Length | 10.16mm |
| Width | 6.477mm |
| Radiation Hardening | No |
| REACH SVHC | No SVHC |
| RoHS Status | RoHS Compliant |
| Lead Free | Lead Free |
LT1013DN8#PBF Overview
Packaging for the buffer amplifier is in the form of a DIP case. 8 pins are included on the operational amplifiers. Op amp ic rates 40μV for input offset voltage. This op amp can operate from a supply current at 350μA. It is recommended to keep the voltage gain at 120dB at all times. On this instrumentation amplifier, there are 2 circuits that are connected together. As far as the device is concerned, buffer amplifier has 2 channels. It is recommended that the temperature of this op amp ic should not fall below 0°C degrees Fahrenheit at any time. Instrumentation amplifier should only be used at temperatures up to 70°C. Depending on the chip's operating supply voltage, op amp ic has a rated voltage of 2. The operating supply voltage of instrumentation amplifier is rated 5V voltage. With regard tp supply voltage, op amp is used under 44V. A voltage of 4V or higher is recommended for the linear amplifier's supply voltage. This electronic part should be conducted with a dual supply voltage of 22V volts for this part. On the linear amplifier, there are 2 amplifiers.
LT1013DN8#PBF Features
120dB voltage gain
LT1013DN8#PBF Applications
There are a lot of Analog Devices, Inc. LT1013DN8#PBF Instrumentational OP Amps applications.
- Automotive sensors
- Integrator circuits
- Professional videography
- Proportional operation circuits
- Hand-held batteries
- Inverse/same-phase proportional circuit
- Instrumentation
- Portable media players
- Radar
- Micro signal measurement
