LT1213CN8#PBF
| Parameters | |
|---|---|
| Max Supply Voltage | 36V |
| Min Supply Voltage | 2.5V |
| Operating Supply Current | 3.4mA |
| Max Supply Current | 7.6mA |
| Slew Rate | 8.5 V/μs |
| Common Mode Rejection Ratio | 86 dB |
| Current - Input Bias | 200nA |
| Output Current per Channel | 50mA |
| Input Offset Voltage (Vos) | 75μV |
| Bandwidth | 28MHz |
| Gain Bandwidth Product | 26MHz |
| Voltage Gain | 118.59dB |
| Power Supply Rejection Ratio (PSRR) | 90dB |
| Max Dual Supply Voltage | 18V |
| Min Dual Supply Voltage | 1.25V |
| Dual Supply Voltage | 15V |
| Nominal Gain Bandwidth Product | 28MHz |
| Number of Amplifiers | 2 |
| Height | 3.3mm |
| Length | 10.16mm |
| Width | 6.48mm |
| Radiation Hardening | No |
| REACH SVHC | No SVHC |
| RoHS Status | RoHS Compliant |
| Lead Free | Lead Free |
| Lifecycle Status | PRODUCTION (Last Updated: 3 months ago) |
| Package / Case | DIP |
| Number of Pins | 8 |
| Max Operating Temperature | 85°C |
| Min Operating Temperature | -40°C |
| Operating Supply Voltage | 28V |
| Number of Elements | 2 |
| Number of Channels | 2 |
| Number of Circuits | 2 |
LT1213CN8#PBF Overview
In the package, you will find a DIP-case to contain the op amp ic. A total of 8 pins are present on the instrumentation amplifier. In terms of the input offset voltage, instrumentation amplifier rates at 75μV. It is possible to operate this buffer amplifier from a supply current of 3.4mA . It is recommended to keep the voltage gain at 118.59dB at all times. A instrumentation amplifier like this has 2 circuits. On the buffer amps, there are 2 channels that can be used. For the buffer op amp to operate properly, it must be above the temperature of -40°C degrees Celsius. At temperatures greater than 85°C, Instrumentation amplifier should not be used. This linear amplifier has a total of 2 elements. The operating supply voltage of instrumentation amplifier is rated 28V voltage. Regarding the voltage of the supply, this electrical part can work from a voltage as low as 36V, and this is an excellent feature. As a general rule, it is advisable to keep the op amp's supply voltage above 2.5V at all times. As a rule of thumb, you should conduct this electronic part under a dual voltage supply of 18V volts. As you can see, the linear amplifier has 2 amplifiers.
LT1213CN8#PBF Features
118.59dB voltage gain
LT1213CN8#PBF Applications
There are a lot of Analog Devices, Inc. LT1213CN8#PBF Instrumentational OP Amps applications.
- Multiplication circuits
- PDA
- Test equipment
- Commercial audio systems
- Tablets
- Ultrasound transducers
- Medical imaging
- Automotive sensors
- Test and measurement instruments
- Information processing
