LT1220CN8#PBF

1 Channels 26mA per Channel 100nA 92 dB Instrumentational OP Amps DIP

Manufacturer: Analog Devices, Inc.
Nocochips NO: 84-LT1220CN8#PBF
Package: DIP
Datasheet: PDF
Stock: 979
Description: 1 Channels 26mA per Channel 100nA 92 dB Instrumentational OP Amps DIP(Kg)

Details

Tags

Parameters
Lifecycle Status	PRODUCTION (Last Updated: 1 week ago)
Package / Case	DIP
Number of Pins	8
Max Operating Temperature	70°C
Min Operating Temperature	0°C
Number of Elements	1
Number of Channels	1
Number of Circuits	1
Max Supply Voltage	36V
Min Supply Voltage	5V
Operating Supply Current	8mA
Slew Rate	250 V/μs
Common Mode Rejection Ratio	92 dB
Current - Input Bias	100nA
Output Current per Channel	26mA
Input Offset Voltage (Vos)	500μV
Bandwidth	45MHz
Gain Bandwidth Product	45MHz
Voltage Gain	93.98dB
Power Supply Rejection Ratio (PSRR)	90dB
Max Dual Supply Voltage	18V
Min Dual Supply Voltage	2.5V
Nominal Gain Bandwidth Product	45MHz
Number of Amplifiers	1
REACH SVHC	No SVHC
RoHS Status	RoHS Compliant
Lead Free	Lead Free

LT1220CN8#PBF Overview

In the package, you will find a DIP-case to contain the op amp ic. There are 8 pins on this chip. Op amp rates 500μV as input offset voltage. It is possible to operate this buffer amplifier from a supply current of 8mA . There should be no change in the voltage gain at 93.98dB. On this instrumentation amplifier, there are 1 circuits that are connected together. There are 1 channels on the operational amplifiers. It should not lower than 0°C to operate buffer amplifier. At temperatures greater than 70°C, Instrumentation amplifier should not be used. There are a total of 1 elements in this linear amplifier. I would like to point out that this electrical component is capable of working from a voltage below 36V as far as the power supply is concerned. To keep the buffer amps' supply voltage higher than 5V. As a rule of thumb, you should conduct this electronic part under a dual voltage supply of 18V volts. There are 1 amplifiers on the op amp.