LT1228CN8#PBF
| Parameters | |
|---|---|
| Lifecycle Status | PRODUCTION (Last Updated: 1 week ago) |
| Package / Case | DIP |
| Number of Pins | 8 |
| Max Operating Temperature | 70°C |
| Min Operating Temperature | 0°C |
| Frequency | 75MHz |
| Operating Supply Voltage | 28V |
| Number of Elements | 1 |
| Number of Channels | 1 |
| Number of Circuits | 1 |
| Max Supply Voltage | 36V |
| Min Supply Voltage | 4V |
| Operating Supply Current | 6mA |
| Max Supply Current | 11mA |
| Slew Rate | 3500 V/μs |
| Common Mode Rejection Ratio | 55 dB |
| Current - Input Bias | 10μA |
| Output Current per Channel | 125mA |
| Input Offset Voltage (Vos) | 500μV |
| Bandwidth | 100MHz |
| Voltage Gain | 65dB |
| Power Supply Rejection Ratio (PSRR) | 60dB |
| Settling Time | 45 ns |
| Max Dual Supply Voltage | 15V |
| -3db Bandwidth | 100MHz |
| Min Dual Supply Voltage | 2V |
| Dual Supply Voltage | 9V |
| Nominal Gain Bandwidth Product | 100MHz |
| Number of Amplifiers | 1 |
| Height | 3.3mm |
| Length | 10.16mm |
| Width | 6.48mm |
| REACH SVHC | No SVHC |
| RoHS Status | RoHS Compliant |
| Lead Free | Lead Free |
LT1228CN8#PBF Overview
There is a DIP case package that contains the instrumentation amplifiers. A total of 8 pins are present on the instrumentation amplifier. Regarding input offset voltage, op amp rates 500μV. You can run this op amp ic on 6mA . You should keep the voltage gain at 65dB for the time being. This op amp ic has 1 circuits. Buffer op amp is equipped with 1 channels on the device. In order for op amp to function properly, the temperature should not be lower than 0°C degrees Celsius. In order to avoid damage to the product, operational amplifiers should only be used at temperatures below 70°C. According to the specifications of the buffer op amp, the operating supply voltage is rated at 1. The operating supply voltage of the buffer op amp is rated at 28V. I would like to point out that this electrical component is capable of working from a voltage below 36V as far as the power supply is concerned. The linear amplifier's supply voltage should be higher than 4V. This electrical part should be conducted under the dual supply voltage of 15V volts when you conduct this part. There are 1 amplifiers on it.
LT1228CN8#PBF Features
65dB voltage gain
LT1228CN8#PBF Applications
There are a lot of Analog Devices, Inc. LT1228CN8#PBF Instrumentational OP Amps applications.
- Strain gauges
- Fast A/D and D/A converters
- Band-stop filter
- Gaming industry
- Voltage regulation circuit
- Laptop
- Industrial control system
- Radar
- Cinema or auditorium audio system
- Automatic control
