LT1360CS8#PBF
| Parameters | |
|---|---|
| Lifecycle Status | PRODUCTION (Last Updated: 1 week ago) |
| Package / Case | SOIC |
| Number of Pins | 8 |
| Max Operating Temperature | 85°C |
| Min Operating Temperature | -40°C |
| Number of Elements | 1 |
| Number of Channels | 1 |
| Number of Circuits | 1 |
| Max Supply Voltage | 36V |
| Min Supply Voltage | 3V |
| Power Dissipation-Max | 399mW |
| Operating Supply Current | 4mA |
| Power Dissipation | 399mW |
| Max Supply Current | 4.8mA |
| Slew Rate | 800 V/μs |
| Common Mode Rejection Ratio | 79 dB |
| Current - Input Bias | 1μA |
| Output Current per Channel | 34mA |
| Input Offset Voltage (Vos) | 300μV |
| Bandwidth | 50MHz |
| Gain Bandwidth Product | 37MHz |
| Voltage Gain | 76.12dB |
| Power Supply Rejection Ratio (PSRR) | 93dB |
| Max Dual Supply Voltage | 18V |
| Min Dual Supply Voltage | 1.5V |
| Dual Supply Voltage | 15V |
| Nominal Gain Bandwidth Product | 50MHz |
| Number of Amplifiers | 1 |
| Height | 1.498mm |
| Length | 5mm |
| Width | 3.988mm |
| Radiation Hardening | No |
| REACH SVHC | No SVHC |
| RoHS Status | RoHS Compliant |
| Lead Free | Lead Free |
LT1360CS8#PBF Overview
Packaged in a SOIC case, the buffer op amp is ready to use. 8 pins are available on the instrumentation amplifier. Op amp ic rates 300μV for input offset voltage. A supply current of 4mA can be used to operate this linear amplifier. There should be no change in the voltage gain at 76.12dB. There are 1 circuits on this op amp. As far as the device is concerned, buffer amplifier has 1 channels. For the buffer op amp to operate properly, it must be above the temperature of -40°C degrees Celsius. It should only be used at temperatures up above 85°C. There are 1 elements in total in this linear amplifier. When it comes to the voltage from which this electrical part will operate, it can operate at a maximum of less than 36V. In order to ensure that the instrumentation amplifier's supply voltage remains above 3V, it is recommended to keep it higher. In order for this electronic part to be conducted successfully, you should use a dual supply voltage of 18V. The buffer amplifier consists of 1 amplifiers.
LT1360CS8#PBF Features
76.12dB voltage gain
LT1360CS8#PBF Applications
There are a lot of Analog Devices, Inc. LT1360CS8#PBF Instrumentational OP Amps applications.
- Portable docking station
- Measurements of Wheatstone bridge
- Displayers for aircraft and air transportation control systems
- Cinema or auditorium audio system
- Switching amplifier
- High/low-pass filter circuit
- Car stereo
- Signal operation
- Radiation thermometry transducers
- Television
