banner_page

LT1495CN8#PBF

2 Channels 1.5mA per Channel 25pA 90 dB Instrumentational OP Amps 3V DIP


  • Manufacturer: Analog Devices, Inc.
  • Nocochips NO: 84-LT1495CN8#PBF
  • Package: DIP
  • Datasheet: PDF
  • Stock: 157
  • Description: 2 Channels 1.5mA per Channel 25pA 90 dB Instrumentational OP Amps 3V DIP(Kg)

Details

Tags

Parameters
Lifecycle Status PRODUCTION (Last Updated: 1 week ago)
Package / Case DIP
Number of Pins 8
Max Operating Temperature 70°C
Min Operating Temperature 0°C
Operating Supply Voltage 3V
Number of Elements 2
Number of Channels 2
Number of Circuits 2
Max Supply Voltage 36V
Min Supply Voltage 2.1V
Operating Supply Current 1.4μA
Max Supply Current 3μA
Slew Rate 0.001 V/μs
Common Mode Rejection Ratio 90 dB
Current - Input Bias 25pA
Output Current per Channel 1.5mA
Input Offset Voltage (Vos) 150μV
Bandwidth 2.7 kHz
Gain Bandwidth Product 2.7 kHz
Voltage Gain 113.98dB
Power Supply Rejection Ratio (PSRR) 90dB
Max Dual Supply Voltage 18V
Min Dual Supply Voltage 1.1V
Dual Supply Voltage 3V
Nominal Gain Bandwidth Product 2.7 kHz
Number of Amplifiers 2
Height 3.3mm
Length 10.16mm
Width 6.48mm
REACH SVHC No SVHC
RoHS Status RoHS Compliant

LT1495CN8#PBF Overview


There is a DIP case package that contains the instrumentation amplifiers. There are 8 pins on this chip. In terms of the input offset voltage, instrumentation amplifier rates at 150μV. A supply current of 1.4μA can be used to operate this linear amplifier. It is a member of the 113.98dB's 113.98dB family. There are 2 circuits on this op amp. 2 channels are available on the instrumentation amplifier. For the buffer op amp to operate properly, it must be above the temperature of 0°C degrees Celsius. Linear amplifier shouldn't be used above 70°C degrees. There is an operating supply voltage rating of 2 for this operational amplifier, which is rated at the manufacturer. The operating supply voltage of the buffer op amp is rated at 3V. I would like to point out that this electrical component is capable of working from a voltage below 36V as far as the power supply is concerned. As a general rule, it is advisable to keep the op amp's supply voltage above 2.1V at all times. In order to conduct this part, you will need to provide dual supply voltages of 18V volts. There are 2 amplifiers on it.

LT1495CN8#PBF Features


113.98dB voltage gain

LT1495CN8#PBF Applications


There are a lot of Analog Devices, Inc. LT1495CN8#PBF Instrumentational OP Amps applications.

  • Test equipment
  • Addition operation circuits
  • Weak signal detection
  • Power control
  • Video amplifiers
  • single/dual op amp sum and difference circuits
  • High gain DC amplifier
  • Communication
  • Television broadcasting equipment
  • Portable media players

Write a review

Note: HTML is not translated!
    Bad           Good