LT1789IS8-1#PBF
| Parameters | |
|---|---|
| Lifecycle Status | PRODUCTION (Last Updated: 1 week ago) |
| Package / Case | SOIC |
| Number of Pins | 8 |
| Resistance | 1.6GOhm |
| Max Operating Temperature | 85°C |
| Min Operating Temperature | -40°C |
| Operating Supply Voltage | 3V |
| Number of Elements | 3 |
| Number of Channels | 1 |
| Number of Circuits | 1 |
| Max Supply Voltage | 36V |
| Min Supply Voltage | 2.2V |
| Operating Supply Current | 85μA |
| Max Supply Current | 95μA |
| Slew Rate | 0.0026 V/μs |
| Common Mode Rejection Ratio | 79 dB |
| Current - Input Bias | 40nA |
| Output Current per Channel | 8.5mA |
| Input Offset Voltage (Vos) | 750μV |
| Bandwidth | 60 kHz |
| Gain Bandwidth Product | 60 kHz |
| Power Supply Rejection Ratio (PSRR) | 90dB |
| Max Dual Supply Voltage | 18V |
| Min Dual Supply Voltage | 1.1V |
| Dual Supply Voltage | 3V |
| Nominal Gain Bandwidth Product | 60 kHz |
| Number of Amplifiers | 1 |
| Height | 1.5mm |
| Length | 5mm |
| Width | 3.99mm |
| Radiation Hardening | No |
| REACH SVHC | No SVHC |
| RoHS Status | RoHS Compliant |
| Lead Free | Lead Free |
LT1789IS8-1#PBF Overview
A SOIC case is used to package the op amp. The op amp ic has an array of 8 pins on it. With regards to the offset voltage of the input, buffer amplifier is rated at 750μV. In order for this instrumentation amplifier to operate, the supply current needs to be between 85μA and 10 . There are 1 circuits on op amps. 1 channels are available on the instrumentation amplifier. In order for this buffer op amp to function, it should have a temperature of at least -40°C degrees Celsius. It should only be used at temperatures up above 85°C. This linear amplifier has a total of 3 elements. The operating supply voltage of the buffer op amp is rated at 3V. The electrical part is capable of being powered by a voltage of under 36V, which means that it can be used with any voltage supply. It is recommended that you keep the instrumentation amplifier's supply voltage higher than 2.2V when using it. In order for this electronic part to be conducted successfully, you should use a dual supply voltage of 18V. During testing, the instrumentation amplifier resistance should remain within a range of 1.6GOhm. A total of 1 instrumentation amplifiers are present on the device.
LT1789IS8-1#PBF Features
Resistance of 1.6GOhm
LT1789IS8-1#PBF Applications
There are a lot of Analog Devices, Inc. LT1789IS8-1#PBF Instrumentational OP Amps applications.
- PDA
- Fission chambers
- Inverse/same-phase proportional circuit
- Voltage regulation circuit
- Non-polarized electrodes
- Video amplifiers
- Power generator
- Image computer boards
- Automotive sensors
- Semiconductor detectors
