LT1886CS8#PBF
| Parameters | |
|---|---|
| Lifecycle Status | PRODUCTION (Last Updated: 1 week ago) |
| Package / Case | SOIC |
| Number of Pins | 8 |
| Max Operating Temperature | 85°C |
| Min Operating Temperature | -40°C |
| Number of Elements | 2 |
| Number of Channels | 2 |
| Number of Circuits | 2 |
| Max Supply Voltage | 13.2V |
| Min Supply Voltage | 4V |
| Operating Supply Current | 7mA |
| Max Supply Current | 16.5mA |
| Slew Rate | 200 V/μs |
| Common Mode Rejection Ratio | 77 dB |
| Current - Input Bias | 1.5μA |
| Output Current per Channel | 800mA |
| Input Offset Voltage (Vos) | 4mV |
| Bandwidth | 700MHz |
| Gain Bandwidth Product | 700MHz |
| Voltage Gain | 81.58dB |
| Power Supply Rejection Ratio (PSRR) | 80dB |
| Max Dual Supply Voltage | 6.6V |
| Min Dual Supply Voltage | 2V |
| Dual Supply Voltage | 3V |
| Nominal Gain Bandwidth Product | 700MHz |
| Number of Amplifiers | 2 |
| Height | 1.5mm |
| Length | 5mm |
| Width | 3.99mm |
| REACH SVHC | No SVHC |
| RoHS Status | RoHS Compliant |
| Lead Free | Lead Free |
LT1886CS8#PBF Overview
A SOIC case is used to package the op amp. It has 8 pins that make up the linear amplifier. Op amp rates 4mV as input offset voltage. A supply current of 7mA can be used to operate this linear amplifier. The voltage gain should stay at 81.58dB. The buffer amp consists of 2 circuits in total. 2 channels are available on the instrumentation amplifier. For the buffer op amp to operate properly, it must be above the temperature of -40°C degrees Celsius. In order to avoid damage to the product, operational amplifiers should only be used at temperatures below 85°C. The buffer op amp is rated for an operating voltage of 2 when it comes to the power supply. This electric component can work from a voltage of under 13.2V as far as supply voltage is concerned. As a rule of thumb, the supply voltage of the op amp should not be lower than 4V. In order for this electronic part to be conducted successfully, you should use a dual supply voltage of 6.6V. On the linear amplifier, there are 2 amplifiers.
LT1886CS8#PBF Features
81.58dB voltage gain
LT1886CS8#PBF Applications
There are a lot of Analog Devices, Inc. LT1886CS8#PBF Instrumentational OP Amps applications.
- Signal operation
- Television broadcasting equipment
- Active probe
- High speed sample
- Radar
- Proportional operation circuits
- Band-stop filter
- RF cable systems
- Portable media players
- Vehicle electronics
