LT1994CMS8#PBF
| Parameters | |
|---|---|
| Lifecycle Status | PRODUCTION (Last Updated: 1 week ago) |
| Package / Case | MSOP |
| Number of Pins | 8 |
| Resistance | 700kOhm |
| Max Operating Temperature | 70°C |
| Min Operating Temperature | -40°C |
| Operating Supply Voltage | 3V |
| Number of Elements | 1 |
| Number of Channels | 1 |
| Number of Circuits | 1 |
| Max Supply Voltage | 12.6V |
| Min Supply Voltage | 2.375V |
| Operating Supply Current | 14.8mA |
| Max Supply Current | 20.5mA |
| Slew Rate | 65 V/μs |
| Common Mode Rejection Ratio | 55 dB |
| Current - Input Bias | 45μA |
| Output Current per Channel | 85mA |
| Input Offset Voltage (Vos) | 2mV |
| Bandwidth | 70MHz |
| Gain Bandwidth Product | 70MHz |
| Voltage Gain | 100dB |
| Power Supply Rejection Ratio (PSRR) | 69dB |
| Max Dual Supply Voltage | 6.3V |
| Min Dual Supply Voltage | 1.1875V |
| Nominal Gain Bandwidth Product | 70MHz |
| Number of Amplifiers | 1 |
| Height | 860μm |
| Length | 3mm |
| Width | 3mm |
| Radiation Hardening | No |
| REACH SVHC | No SVHC |
| RoHS Status | RoHS Compliant |
| Lead Free | Lead Free |
LT1994CMS8#PBF Overview
In order to protect the op amps, a MSOP case is used. 8 pins are included on the operational amplifiers. As far as the input offset voltage is concerned, linear amplifier rates at 2mV. As long as the supply current of the chip does not exceed 14.8mA, this op amp ic can operate. It is recommended to keep the voltage gain at 100dB at all times. There are 1 circuits on this op amp. Instrumentation amplifier has 1 channels on it. For this linear amplifier to work, the temperature should not be below -40°C. You should only use op amp buffer at temperatures that are no higher than 70°C. The total number of elements in this buffer amplifier is 1. The operating supply voltage of instrumentation amplifier is rated 3V voltage. With regard tp supply voltage, op amp is used under 12.6V. It is advised to keep the op amp's supply voltage higher than 2.375V. It is recommended that you conduct this electronic part using the dual supply voltage of 6.3V. It is important to keep the resistance within the 700kOhm range of the op amps. On the linear amplifier, there are 1 amplifiers that are used.
LT1994CMS8#PBF Features
100dB voltage gain
Resistance of 700kOhm
LT1994CMS8#PBF Applications
There are a lot of Analog Devices, Inc. LT1994CMS8#PBF Instrumentational OP Amps applications.
- Thermocouples
- Scintillation detectors
- Communication
- Proportional operation circuits
- Multiplication circuits
- Television broadcasting equipment
- Industrial applications including automation
- Polarized electrodes
- Weak signal detection
- Voltage regulation circuit
