LT1999CS8-10#PBF
| Parameters | |
|---|---|
| Factory Lead Time | 1 Week |
| Mounting Type | Surface Mount |
| Package / Case | 8-SOIC (0.154, 3.90mm Width) |
| Surface Mount | YES |
| Operating Temperature | 0°C~70°C |
| Packaging | Tube |
| Published | 2012 |
| JESD-609 Code | e3 |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Number of Terminations | 8 |
| ECCN Code | EAR99 |
| Terminal Finish | Matte Tin (Sn) |
| Subcategory | Operational Amplifier |
| Technology | BIPOLAR |
| Terminal Position | DUAL |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | NOT SPECIFIED |
| Number of Functions | 1 |
| Supply Voltage | 5V |
| Time@Peak Reflow Temperature-Max (s) | NOT SPECIFIED |
| Base Part Number | LT1999 |
| Pin Count | 8 |
| JESD-30 Code | R-PDSO-G8 |
| Qualification Status | Not Qualified |
| Power Supplies | 5V |
| Number of Circuits | 1 |
| Current - Supply | 5.8mA |
| Slew Rate | 3V/μs |
| Amplifier Type | Current Sense |
| Common Mode Rejection Ratio | 120 dB |
| Current - Input Bias | 137.5μA |
| Voltage - Supply, Single/Dual (±) | 4.5V~5.5V |
| Supply Voltage Limit-Max | 6V |
| Voltage - Input Offset | 500μV |
| -3db Bandwidth | 2MHz |
| Length | 4.9mm |
| RoHS Status | ROHS3 Compliant |
LT1999CS8-10#PBF Overview
Packaging for the buffer amplifier is in the form of a 8-SOIC (0.154, 3.90mm Width) case. Op amps are Current Sense types of amplifier on the chip. In the case of Tube cases, linear amplifier will be delivered. The number of terminations approaches 8. In this case, there are 8 pins on the board. It would be helpful if you could remember that this op amp ic should be powered by an 5V battery. To be specific, this instrumentation amplifier is a type of Operational Amplifier. It is recommended that this electronic component be mounted using the Surface Mount mounting type. According to the manufacturer, this buffer op amp works well at 0°C~70°C , which is a good operating temperature. There are 1 circuits on this op amp. To run supply current of buffer amplifier under 5.8mA.
LT1999CS8-10#PBF Features
8 Pins
supply voltage of 5V
LT1999CS8-10#PBF Applications
There are a lot of Linear Technology/Analog Devices LT1999CS8-10#PBF Instrumentational OP Amps applications.
- Tablets
- Portable electronic products powered by batteries
- Logarithmic operation circuits
- Active probe
- Television broadcasting equipment
- Signal filtering
- Communication
- Weak signal detection
- Biopotential
- Semiconductor detectors
