LT6207CGN#PBF
| Parameters | |
|---|---|
| Lifecycle Status | PRODUCTION (Last Updated: 1 week ago) |
| Package / Case | SSOP |
| Number of Pins | 16 |
| Max Operating Temperature | 70°C |
| Min Operating Temperature | 0°C |
| Operating Supply Voltage | 12V |
| Number of Elements | 4 |
| Number of Channels | 4 |
| Number of Circuits | 4 |
| Max Supply Voltage | 12.6V |
| Min Supply Voltage | 3V |
| Operating Supply Current | 4mA |
| Current - Output | 50mA |
| Slew Rate | 600 V/μs |
| Common Mode Rejection Ratio | 78 dB |
| Current - Input Bias | 30μA |
| Output Current per Channel | 60mA |
| Input Offset Voltage (Vos) | 4.5mV |
| Bandwidth | 100MHz |
| Gain Bandwidth Product | 100MHz |
| Voltage Gain | 100dB |
| Power Supply Rejection Ratio (PSRR) | 67dB |
| Max Dual Supply Voltage | 6.3V |
| Min Dual Supply Voltage | 1.35V |
| Dual Supply Voltage | 5V |
| Nominal Gain Bandwidth Product | 100MHz |
| Number of Amplifiers | 4 |
| Height | 1.5mm |
| Length | 4.98mm |
| Width | 3.99mm |
| REACH SVHC | No SVHC |
| RoHS Status | RoHS Compliant |
| Lead Free | Lead Free |
LT6207CGN#PBF Overview
The linear amplifier is packaged in a SSOP case. 16 pins are included on the operational amplifiers. Regarding input offset voltage, op amp rates 4.5mV. In order for this instrumentation amplifier to operate, the supply current needs to be between 4mA and 10 . There should be no change in the voltage gain. This op amp ic has 4 circuits. 4 channels are available on the instrumentation amplifier. In order for this buffer op amp to function, it should have a temperature of at least 0°C degrees Celsius. You should only use op amp buffer at temperatures that are no higher than 70°C. There is an operating supply voltage rating of 4 for this operational amplifier, which is rated at the manufacturer. The operating supply voltage of instrumentation amplifier is rated 12V voltage. The electrical part is capable of being powered by a voltage of under 12.6V, which means that it can be used with any voltage supply. Over 3V is a recommended supply voltage for buffer ampsIn order for this electronic part to be conducted successfully, you should use a dual supply voltage of 6.3V. The buffer amplifier consists of 4 amplifiers.
LT6207CGN#PBF Features
100dB voltage gain
LT6207CGN#PBF Applications
There are a lot of Analog Devices, Inc. LT6207CGN#PBF Instrumentational OP Amps applications.
- Scintillation detectors
- Band-pass filter
- Micro signal measurement
- Measurements of Wheatstone bridge
- Information processing
- pH (acidity)
- Digital cameras
- Biopotential
- Mobile phone
- High input resistance broadband
