LT6402IUD-12#TRPBF

1 Channels 35mA per Channel 5μA 42 dB Instrumentational OP Amps 5V QFN EP

Manufacturer: Analog Devices, Inc.
Nocochips NO: 84-LT6402IUD-12#TRPBF
Package: QFN EP
Datasheet: PDF
Stock: 503
Description: 1 Channels 35mA per Channel 5μA 42 dB Instrumentational OP Amps 5V QFN EP(Kg)

Details

Tags

Parameters
Package / Case	QFN EP
Number of Pins	16
Resistance	122Ohm
Max Operating Temperature	85°C
Min Operating Temperature	-40°C
Operating Supply Voltage	5V
Number of Elements	1
Number of Channels	1
Number of Circuits	2
Max Supply Voltage	5.5V
Min Supply Voltage	4V
Operating Supply Current	30mA
Slew Rate	400 V/μs
Common Mode Rejection Ratio	42 dB
Current - Input Bias	5μA
Output Current per Channel	35mA
Input Offset Voltage (Vos)	6.5mV
Bandwidth	300MHz
Voltage Gain	12.4dB
Power Supply Rejection Ratio (PSRR)	55dB
-3db Bandwidth	300MHz
Nominal Gain Bandwidth Product	300MHz
RoHS Status	RoHS Compliant
Lifecycle Status	PRODUCTION (Last Updated: 1 week ago)

LT6402IUD-12#TRPBF Overview

The linear amplifier is packaged in a QFN EP case. 16 pins are located on the operational amplifiers. Op amp rates 6.5mV as input offset voltage. Operational amplifier can operate supply current at 30mA. 12.4dB should remain the voltage gain. There are 2 circuits on this op amp. Buffer op amp is equipped with 1 channels on the device. For the buffer op amp to operate properly, it must be above the temperature of -40°C degrees Celsius. You should only use op amp buffer at temperatures that are no higher than 85°C. Depending on the chip's operating supply voltage, op amp ic has a rated voltage of 1. The operating supply voltage of the buffer op amp is rated at 5V. When it comes to the voltage from which this electrical part will operate, it can operate at a maximum of less than 5.5V. Over 4V is a recommended supply voltage for buffer ampsIt is recommended to keep the instrumentation amplifier resistance within the range of 122Ohm.