LTC1629IG-PG#TRPBF
| Parameters | |
|---|---|
| Factory Lead Time | 1 Week |
| Mounting Type | Surface Mount |
| Package / Case | 28-SSOP (0.209, 5.30mm Width) |
| Surface Mount | YES |
| Operating Temperature | -40°C~85°C TA |
| Packaging | Tape & Reel (TR) |
| Published | 2000 |
| Series | PolyPhase® |
| JESD-609 Code | e3 |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Number of Terminations | 28 |
| ECCN Code | EAR99 |
| Terminal Finish | Matte Tin (Sn) |
| Technology | CMOS |
| Terminal Position | DUAL |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | 260 |
| Terminal Pitch | 0.65mm |
| Time@Peak Reflow Temperature-Max (s) | 30 |
| Base Part Number | LTC1629 |
| Function | Step-Down |
| Number of Outputs | 2 |
| Output Type | Transistor Driver |
| Input Voltage-Nom | 15V |
| Analog IC - Other Type | DUAL SWITCHING CONTROLLER |
| Output Configuration | Positive |
| Voltage - Supply (Vcc/Vdd) | 4V~36V |
| Control Features | Enable, Phase Control, Power Good, Soft Start |
| Input Voltage (Min) | 4V |
| Topology | Buck |
| Control Mode | CURRENT-MODE |
| Output Current-Max | 5A |
| Frequency - Switching | 220kHz |
| Input Voltage (Max) | 36V |
| Control Technique | PULSE WIDTH MODULATION |
| Synchronous Rectifier | Yes |
| Switcher Configuration | PUSH-PULL |
| Duty Cycle (Max) | 99.5% |
| Clock Sync | No |
| Width | 5.3mm |
| RoHS Status | ROHS3 Compliant |
LTC1629IG-PG#TRPBF Overview
This switching controller fits most application requirements since it is packaged in a 28-SSOP (0.209, 5.30mm Width) package. 2 outputs can be generated with the dc motor controller. There is a Tape & Reel (TR) solid enclosure around the pmic. It is capable of handling Transistor Driver dc switching's outputs (s). 4V~36V is the operating voltage and supply voltage of the dc control. A -40°C~85°C TA dc switcher is not a problem. This switching controller can switch at 220kHz. As it has a Surface Mount value, it can be used for general dc dc regulator. Switching control is made easier with the dcdc regulator's Enable, Phase Control, Power Good, Soft Start. An analog IC with the DUAL SWITCHING CONTROLLER signal is connected to the switch converters. A switching converters's terminal (s) sits at the DUAL position. An array of 28 terminations of dc switching. These dc dc converter ics adapt a variety of control techniques, including PULSE WIDTH MODULATION. DC switcher's voltage input of 15V. You can find other relevant dc to dc converter ics by searching "LTC1629". It is recommended to use 4V as the minimum input voltage of dc dc voltage regulator. It should be fully noted that the dc to dc regulator only accepts 36V input voltage at most. A maximum value of 5A is output for current. PolyPhase? is a series of dc to dc voltage regulator.
LTC1629IG-PG#TRPBF Features
Transistor Driver Outputs
Switching Frequency: 220kHz
Enable, Phase Control, Power Good, Soft Start
PULSE WIDTH MODULATION
LTC1629IG-PG#TRPBF Applications
There are a lot of Linear Technology/Analog Devices LTC1629IG-PG#TRPBF DC to DC converter applications.
- Printing equipment
- Automatic testing equipment
- Balance equipment
- Elevator lighting
- Wide-range voltage regulation circuits
- Power supplies of electronic gadgets
- Radio equipment
- Telecommunications equipment
- Computed tomography (CT)
- Magnetohydrodynamic power
