Parameters |
Factory Lead Time |
1 Week |
Mounting Type |
Surface Mount |
Package / Case |
8-WFDFN Exposed Pad |
Surface Mount |
YES |
Operating Temperature |
0°C~70°C |
Packaging |
Tube |
Published |
2011 |
JESD-609 Code |
e3 |
Part Status |
Active |
Moisture Sensitivity Level (MSL) |
1 (Unlimited) |
Number of Terminations |
8 |
ECCN Code |
EAR99 |
Type |
Buffer, Accelerator |
Terminal Finish |
Matte Tin (Sn) |
Applications |
I2C - Hotswap |
Technology |
CMOS |
Voltage - Supply |
2.9V~5.5V |
Terminal Position |
DUAL |
Terminal Form |
NO LEAD |
Peak Reflow Temperature (Cel) |
NOT SPECIFIED |
Number of Functions |
1 |
Supply Voltage |
3.3V |
Terminal Pitch |
0.5mm |
Time@Peak Reflow Temperature-Max (s) |
NOT SPECIFIED |
Base Part Number |
LTC4313 |
Output |
2-Wire Bus |
Pin Count |
8 |
JESD-30 Code |
S-PDSO-N8 |
Supply Voltage-Max (Vsup) |
5.5V |
Supply Voltage-Min (Vsup) |
2.9V |
Number of Channels |
1 |
Current - Supply |
8.1mA |
Input |
2-Wire Bus |
Data Rate (Max) |
400kHz |
Capacitance - Input |
10pF |
Height Seated (Max) |
0.8mm |
Length |
3mm |
Width |
3mm |
RoHS Status |
ROHS3 Compliant |
LTC4313CDD-2#PBF Overview
For ease of transportation, the power buffer is packaged in 8-WFDFN Exposed Pad.Currently available in Tube packages for power buffer.Surface Mount Universal mout to make it easier for you to adjust.As far as types are concerned, this is just a typical Buffer, Accelerator.The op amp buffer uses a voltage of 2.9V~5.5V volts for its operation.The output quality is maintained by 1 channels.2-Wire Bus input can be accommodated.It is recommended that the operating temperature is set to 0°C~70°C to prevent malfunctions.In addition to I2C - Hotswap, this operational amplifier buffer may also be used for other applications.To get more pin-to-pin solutions for your special needs, try searching a higher letter such as "LTC4313" instead of "s".There are 8 terminals on the op amp buffer that you can find.During reflow, it reaches a temperature of NOT SPECIFIED.With its 3.3V voltage supply, the splitter can perform many demanding functions that are expected from it.It starts with the 8 pins of the Power buffer in order to determine the pinout of the Power buffer.2-Wire Bus is the output unit.There are 8.1mA op amp buffers in it.A voltage higher than 5.5V should not be applied to the repeter. It is not recommended that you do so.To start it up, the splitter will need 2.9V at least.
LTC4313CDD-2#PBF Features
1 channels.
Mainly used in I2C - Hotswap.
LTC4313CDD-2#PBF Applications
There are a lot of Linear Technology/Analog Devices LTC4313CDD-2#PBF Signal Buffers, Repeaters, Splitters applications.
- Network Switches/Routers
- Portable IPC/HMI
- Desktop Computers
- Industrial Server
- Data or Clock Signal Amplification
- Industrial/Embedded PC
- Cable Repeaters
- Loopback
- Storage Area Networks
- Backplane Interconnect