LTC4353IDE#PBF
| Parameters | |
|---|---|
| Factory Lead Time | 1 Week |
| Mounting Type | Surface Mount |
| Package / Case | 16-WFDFN Exposed Pad |
| Surface Mount | YES |
| Operating Temperature | -40°C~85°C |
| Packaging | Tube |
| Published | 2012 |
| JESD-609 Code | e3 |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Number of Terminations | 16 |
| ECCN Code | EAR99 |
| Type | Current Sharing Controller |
| Terminal Finish | Matte Tin (Sn) |
| Applications | Redundant Power Supplies, Telecom Infrastructure |
| HTS Code | 8542.39.00.01 |
| Subcategory | Power Management Circuits |
| Technology | CMOS |
| Voltage - Supply | 2.9V~18V |
| Terminal Position | DUAL |
| Number of Functions | 1 |
| Supply Voltage | 12V |
| Terminal Pitch | 0.45mm |
| Base Part Number | LTC4353 |
| Pin Count | 16 |
| JESD-30 Code | R-PDSO-N16 |
| Supply Voltage-Max (Vsup) | 18V |
| Power Supplies | 12V |
| Supply Voltage-Min (Vsup) | 2.9V |
| Number of Channels | 2 |
| Adjustable Threshold | NO |
| Current - Supply | 1.5mA |
| FET Type | N-Channel |
| Supply Current-Max (Isup) | 2.5mA |
| Ratio - Input:Output | 2:2 |
| Internal Switch(s) | No |
| Delay Time - OFF | 300ns |
| Delay Time - ON | 400ns |
| Height Seated (Max) | 0.8mm |
| Length | 4mm |
| Width | 3mm |
| RoHS Status | ROHS3 Compliant |
LTC4353IDE#PBF Overview
There is a 16-WFDFN Exposed Pad case that comes with it. Tube cases are suitable for packing the part. Surface Mount is used to mount the part. There is a voltage of 2.9V~18V applied to it. The minimum operating temperature of this component must not be -40°C~85°C. A component connected in Redundant Power Supplies, Telecom Infrastructure would be a good fit for it. There is a Current Sharing Controller category assigned to the device. A N-Channel-type FET can be identified. Among the options available for the part are 16 terminations. Pins are attached to it using 16 pins. LTC4353 underpins the part. In order to deliver its performance, it is powered by 12V. Using 1.5mA to run part supply current. There is a part of the Power Management Circuits family that is used in this part. This part should have a voltage supply of at least 2.9V (Vsup). 18V represents the maximum supply voltage (Vsup). If 2.5mA is greater than 0, the supply current (Isup) should conduct. The voltage at 12V can be delivered by it.
LTC4353IDE#PBF Features
in a 16-WFDFN Exposed Pad case
FET Type: N-Channel
16 terminations
LTC4353IDE#PBF Applications
There are a lot of Linear Technology/Analog Devices LTC4353IDE#PBF Ideal Diode controller applications.
- Cell phones
- PDAs
- Modems
- Automotive battery protection
- Camera ECU
- Motor drives
- AC Rectifier
- Active OR-ing of Redundant (N+1) Power Supplies
- Power supply reverse polarity protection
- Factory automation and control - PLC digital output modules
