banner_page

MAX13253ATB+T

N-Channel 0.5mm Tin PMIC MAX13253 10 Pin 5V 10-WFDFN Exposed Pad


  • Manufacturer: Maxim Integrated
  • Nocochips NO: 503-MAX13253ATB+T
  • Package: 10-WFDFN Exposed Pad
  • Datasheet: PDF
  • Stock: 588
  • Description: N-Channel 0.5mm Tin PMIC MAX13253 10 Pin 5V 10-WFDFN Exposed Pad (Kg)

Details

Tags

Parameters
Factory Lead Time 1 Week
Contact Plating Tin
Mount Surface Mount
Mounting Type Surface Mount
Package / Case 10-WFDFN Exposed Pad
Number of Pins 10
Operating Temperature -40°C~150°C TJ
Packaging Tape & Reel (TR)
Published 2013
Feature Watchdog Timer
Part Status Active
Moisture Sensitivity Level (MSL) 1 (Unlimited)
Number of Terminations 10
Technology BICMOS
Terminal Position DUAL
Number of Functions 1
Supply Voltage 5V
Terminal Pitch 0.5mm
Base Part Number MAX13253
Number of Outputs 2
Output Type N-Channel
Max Output Current 1A
Supply Voltage-Max (Vsup) 5.5V
Supply Voltage-Min (Vsup) 3V
Interface On/Off
Analog IC - Other Type ANALOG CIRCUIT
Output Configuration Low Side
Voltage - Supply (Vcc/Vdd) Not Required
Switch Type General Purpose
Ratio - Input:Output 1:2
Voltage - Load 3V~5.5V
Fault Protection Current Limiting (Fixed), Over Temperature, UVLO
Rds On (Typ) 145m Ω
Height Seated (Max) 0.8mm
Length 3mm
Width 3mm
Radiation Hardening No
REACH SVHC Unknown
RoHS Status ROHS3 Compliant

MAX13253ATB+T Overview


As you can see, it's packaged in the way of a Tape & Reel (TR).There is a 10-WFDFN Exposed Pad package that includes it.The LED driver is mounted as Surface Mount.There is a switch type of General Purpose.To ensure reliable operation, the temperature should be set to -40°C~150°C TJ.In this LED driver, there are no outputs available.In order to operate, it requires a voltage supply of Not Required.A maximum output voltage of N-Channel volts has been specified.A lighting driver with Watchdog Timer features is available.It is part of the MAX13253 family of LED drivers.The termination count is 10.The operation is performed through the 10 pins.The LED driving board has a total of 1 functions.As a result, the maximum output current is reduced to 1A in order to meet the operation requirements.It is possible to obtain high efficiency with a supply voltage of 5V.Surface Mount is mounted in the way.In this case, Vsup (maximum supply voltage) is set to 5.5V.In order to operate normally, the supply voltage (Vsup) must remain above 3V.In this case, the analog IC in this gadget is ANALOG CIRCUIT.

MAX13253ATB+T Features


Supplied from 5V

MAX13253ATB+T Applications


There are a lot of Maxim Integrated MAX13253ATB+T Power Switches ICs applications.

  • Hot Swap
  • PC Card Hot Swap
  • Notebook and Tablet Computers
  • USB Protection
  • Gaming
  • Low Voltage I/O System Power
  • Portable Devices
  • Handheld Devices
  • USB Ports/Hubs
  • Portable GPS

Write a review

Note: HTML is not translated!
    Bad           Good