MAX14594EEWL+T
| Parameters | |
|---|---|
| Factory Lead Time | 1 Week |
| Mounting Type | Surface Mount |
| Package / Case | 9-WFBGA, WLBGA |
| Number of Pins | 9 |
| Operating Temperature | -40°C~85°C TA |
| Packaging | Tape & Reel (TR) |
| Published | 2014 |
| Pbfree Code | yes |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Resistance | 380mOhm |
| Max Power Dissipation | 963.8mW |
| Operating Supply Voltage | 2.5V |
| Number of Circuits | 1 |
| Max Supply Voltage | 5.5V |
| Min Supply Voltage | 1.6V |
| Max Supply Current | 60μA |
| Turn On Delay Time | 10 ms |
| Supply Type | Dual, Single |
| Turn-Off Delay Time | 2.25 ms |
| -3db Bandwidth | 200MHz |
| On-State Resistance (Max) | 380mOhm |
| Dual Supply Voltage | 5V |
| Multiplexer/Demultiplexer Circuit | 2:2 |
| Current - Leakage (IS(off)) (Max) | 400nA |
| Channel Capacitance (CS(off), CD(off)) | 25pF |
| Switch Circuit | DPDT |
| Switch Time (Ton, Toff) (Max) | 10ms, 2.25ms |
| Channel-to-Channel Matching (ΔRon) | 5m Ω |
| Crosstalk | -80dB @ 100kHz |
| Voltage - Supply, Single (V+) | 1.6V~5.5V |
| Radiation Hardening | No |
| RoHS Status | ROHS3 Compliant |
MAX14594EEWL+T Overview
Due to its 9-WFBGA, WLBGA packaging, the electronic part is convenient for international shipping. This high-reliability packaging method uses advanced packaging methods Tape & Reel (TR). A switch device like this is mounted in Surface Mount. The ratio between the number of multiplexer and demultiplexer circuits is 2:2. Temperatures around -40°C~85°C TA are extended for operation. On the other hand, analog switches can be constructed using DPDT switching circuits. There are 1 circuits in this multiplexer. An switch multiplexer with 380mOhm internal resistance has a value of 380mOhm. Datasheets for 9 pin functions are available upon request. In a normalsituation, users should not supply the switches with voltage higher than 5.5V. Digital switch that provides Dual, Single power at a cost-effective price. There should be 1.6V voltage fed to the electrical part below 1.6V. Analogue multiplexers require a 1.6V~5.5V voltage to drain from a single voltage supply. It may damage the digital multiplexer if the voltage is higher than 60μA. A voltage of 2.5V can be used to operate the electronic component.
MAX14594EEWL+T Features
Switch Circuit: DPDT
-3db Bandwidth: 200MHz
MAX14594EEWL+T Applications
There are a lot of Maxim Integrated MAX14594EEWL+T Analog Switches & Multiplexers ICs applications.
- PDH Multiplexers
- PDAs
- Multiplexers
- Audio signal routing
- SONET
- Access Concentrators
- Wireless Local Loop
- ISDN NT1/TA
- Medical Instrumentation
- Switching Systems
