MAX14762ETB+T

200μs, 400μs SPST - NO/NC 20Ohm DUAL Analog Switches BREAK-BEFORE-MAKE MAX14762 10nA 10-WFDFN Exposed Pad

Manufacturer: Maxim Integrated
Nocochips NO: 503-MAX14762ETB+T
Package: 10-WFDFN Exposed Pad
Datasheet: PDF
Stock: 434
Description: 200μs, 400μs SPST - NO/NC 20Ohm DUAL Analog Switches BREAK-BEFORE-MAKE MAX14762 10nA 10-WFDFN Exposed Pad(Kg)

Details

Tags

Parameters
Factory Lead Time	1 Week
Mount	Surface Mount
Mounting Type	Surface Mount
Package / Case	10-WFDFN Exposed Pad
Number of Pins	10
Operating Temperature	-40°C~85°C TA
Packaging	Tape & Reel (TR)
Published	2012
Part Status	Active
Moisture Sensitivity Level (MSL)	1 (Unlimited)
Number of Terminations	10
Resistance	20Ohm
Subcategory	Multiplexer or Switches
Technology	BICMOS
Terminal Position	DUAL
Number of Functions	2
Terminal Pitch	0.5mm
Base Part Number	MAX14762
Output	SEPARATE OUTPUT
Power Supplies	3.3/5V
Number of Circuits	2
Max Supply Voltage	5.5V
Min Supply Voltage	3V
Operating Supply Current	4.1mA
Throw Configuration	SPST
Supply Type	Single
-3db Bandwidth	115MHz
On-State Resistance (Max)	20Ohm
Multiplexer/Demultiplexer Circuit	1:1
Current - Leakage (IS(off)) (Max)	10nA
Channel Capacitance (CS(off), CD(off))	32pF
Switch Circuit	SPST - NO/NC
Switch Time (Ton, Toff) (Max)	200μs, 400μs
Charge Injection	19pC
Crosstalk	-92dB @ 100kHz
Switching	BREAK-BEFORE-MAKE
Voltage - Supply, Single (V+)	3V~5.5V
Radiation Hardening	No
RoHS Status	ROHS3 Compliant

MAX14762ETB+T Overview

The electrical component comes in 10-WFDFN Exposed Pad packaging, which makes it convenient to ship overseas. To ensure high reliability, a new packaging method Tape & Reel (TR) is used. The multiplexer is located in Surface Mount. The ratio between the number of multiplexer and demultiplexer circuits is 1:1. Operation at a temperature around -40°C~85°C TA. Total terminations are 10. Based on SPST - NO/NC switching circuits, these analog multiplexers work. A 2 circuit is present in this switch device. MAX14762 can be used to search for analog multiplexer variants. Internally, this switch multiplexer has a resistance of 20Ohm. The functions of 10 pins can be found in the datasheets. The analog multiplexer shown here is a typical Multiplexer or Switches. Users shouldn't supply more than 5.5V voltage to the switch device. The digital multiplexer has a low cost Single supply. There should be 3V voltage fed to the electrical part below 3V. This multiplexer would work with 4.1mA current. A voltage of 3V~5.5V is required for this switch device, which drains from a single voltage source. There are SEPARATE OUTPUT outputs on this analog switch ic.