MAX14764ETA+T

200μs, 400μs SPDT 20Ohm DUAL Analog Switches BREAK-BEFORE-MAKE MAX14764 10nA 8-WFDFN Exposed Pad

Manufacturer: Maxim Integrated
Nocochips NO: 503-MAX14764ETA+T
Package: 8-WFDFN Exposed Pad
Datasheet: PDF
Stock: 556
Description: 200μs, 400μs SPDT 20Ohm DUAL Analog Switches BREAK-BEFORE-MAKE MAX14764 10nA 8-WFDFN Exposed Pad(Kg)

Details

Tags

Parameters
Factory Lead Time	1 Week
Mount	Surface Mount
Mounting Type	Surface Mount
Package / Case	8-WFDFN Exposed Pad
Number of Pins	8
Operating Temperature	-40°C~85°C TA
Packaging	Tape & Reel (TR)
Published	2012
Part Status	Active
Moisture Sensitivity Level (MSL)	1 (Unlimited)
Number of Terminations	8
Resistance	20Ohm
Subcategory	Multiplexer or Switches
Technology	BICMOS
Terminal Position	DUAL
Number of Functions	1
Terminal Pitch	0.635mm
Base Part Number	MAX14764
Power Supplies	3.3/5V
Number of Circuits	1
Max Supply Voltage	5.5V
Min Supply Voltage	3V
Analog IC - Other Type	SPST
Operating Supply Current	4.1mA
Supply Type	Single
-3db Bandwidth	115MHz
On-State Resistance (Max)	20Ohm
Multiplexer/Demultiplexer Circuit	2:1
Current - Leakage (IS(off)) (Max)	10nA
Channel Capacitance (CS(off), CD(off))	32pF
Switch Circuit	SPDT
Switch Time (Ton, Toff) (Max)	200μs, 400μs
Charge Injection	19pC
Crosstalk	-92dB @ 100kHz
Switching	BREAK-BEFORE-MAKE
Voltage - Supply, Single (V+)	3V~5.5V
Radiation Hardening	No
RoHS Status	ROHS3 Compliant

MAX14764ETA+T Overview

The electronic part can be shipped overseas conveniently because it is packaged in 8-WFDFN Exposed Pad. In order to provide high reliability, an advanced packaging method Tape & Reel (TR) is used. In Surface Mount, you'll find this switch device. Multiplexer and demultiplexer circuits have a number 2:1. Temperatures around -40°C~85°C TA are extended for operation. The total number of terminations is 8. Multiplexers built on a SPDT switching circuit are built. A total of 1 circuits make up this switch device. Try searching for MAX14764 variants of the analog switch ic. There is 20Ohm internal resistance in this digital multiplexer. For functions related to 8 pins, please refer to the datasheets. Theswitch device is a typical Multiplexer or Switches. An abnormal situation would be for the switch device to be supplied with a voltage greater than 5.5V. Analogue multiplexer with a Single supply type that is cost-effective. 3V is the lowest voltage the electrical component should receive. It would be sufficient to run this analogue multiplexer with 4.1mA current. A voltage of 3V~5.5V is required to drain this analog switch from a single voltage supply. An analog IC with the number SPST is integrated into this board.