MAX1898EUB42
| Parameters | |
|---|---|
| Mount | Surface Mount |
| Package / Case | UMAX |
| Number of Pins | 10 |
| Published | 2002 |
| JESD-609 Code | e0 |
| Pbfree Code | no |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 1 |
| Number of Terminations | 10 |
| Termination | SMD/SMT |
| ECCN Code | EAR99 |
| Max Operating Temperature | 85°C |
| Min Operating Temperature | -40°C |
| Subcategory | Power Management Circuits |
| Technology | BICMOS |
| Terminal Position | DUAL |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | 240 |
| Number of Functions | 1 |
| Supply Voltage | 8V |
| Terminal Pitch | 0.5mm |
| Time@Peak Reflow Temperature-Max (s) | 20 |
| Pin Count | 10 |
| Operating Supply Voltage | 12V |
| Power Supplies | 8V |
| Temperature Grade | INDUSTRIAL |
| Number of Channels | 2 |
| Max Supply Voltage | 12V |
| Min Supply Voltage | 4.5V |
| Analog IC - Other Type | POWER SUPPLY SUPPORT CIRCUIT |
| Operating Supply Current | 2mA |
| Current - Output | 1.4A |
| Adjustable Threshold | YES |
| Voltage - Output | 4.2V |
| Max Input Voltage | 12V |
| Nominal Input Voltage | 12V |
| Number of Cells | 1 |
| Charge Current - Max | 1.4A |
| Length | 3mm |
| Width | 3mm |
| Radiation Hardening | No |
| REACH SVHC | No SVHC |
| RoHS Status | RoHS Compliant |
| Lead Free | Lead Free |
MAX1898EUB42 Overview
This package corresponds to UMAX. A device like this uses an analog IC named POWER SUPPLY SUPPORT CIRCUIT. It is possible to access 2 channels. The device has 10 pins in total. To mount this component, use Surface Mount. It is recommended that this part's minimum supply voltage not be less than 4.5V volts. The electrical component belongs to the Power Management Circuits family. It is recommended that the chip's supply voltage not exceed 12V volts. A value of -40°C is required to activate this device. Using it below 85°C temperatures is recommended. Power comes from a 8V volt source. You should leave this device set to 8V at all times. It has 10 pins in total. This device's operating supply voltage is specified as being in the range of 12V. Its output voltage amounts to 4.2V. Chips can be powered by this voltage under 12V. Powering the battery under 1.4A is recommended for battery safety. This device operates on a 2mA volt supply current.
MAX1898EUB42 Features
Available in UMAX Package
with 10 Pins
operate supply voltage at the range of 8V
MAX1898EUB42 Applications
There are a lot of Maxim Integrated MAX1898EUB42 Battery Management ICs applications.
- Shuttle robots
- Trucks
- TFT cluster
- Passenger cars
- xEV charging station (off-board charger)
- Continually optimizing battery performance
- Rear light with dynamic control
- 3-wheelers
- Electric train traction batteries
- Power tools
