MAX309CUE+
| Parameters | |
|---|---|
| Factory Lead Time | 1 Week |
| Mount | Surface Mount |
| Mounting Type | Surface Mount |
| Package / Case | 16-TSSOP (0.173, 4.40mm Width) |
| Number of Pins | 16 |
| Operating Temperature | 0°C~70°C TA |
| Packaging | Tube |
| Published | 2002 |
| JESD-609 Code | e3 |
| Pbfree Code | yes |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Number of Terminations | 16 |
| ECCN Code | EAR99 |
| Resistance | 175Ohm |
| Terminal Finish | Matte Tin (Sn) |
| Max Power Dissipation | 457mW |
| Technology | CMOS |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | 260 |
| Number of Functions | 2 |
| Supply Voltage | 15V |
| Terminal Pitch | 0.65mm |
| Time@Peak Reflow Temperature-Max (s) | 30 |
| Base Part Number | MAX309 |
| Pin Count | 16 |
| Operating Supply Voltage | 28V |
| Number of Channels | 4 |
| Number of Circuits | 2 |
| Max Supply Voltage | 30V |
| Min Supply Voltage | 5V |
| Operating Supply Current | 500μA |
| Throw Configuration | 4PST |
| Propagation Delay | 175 ns |
| Turn On Delay Time | 600 ns |
| Logic Function | Multiplexer |
| Voltage - Supply, Single/Dual (±) | 5V~30V ±5V~20V |
| Supply Type | Dual, Single |
| Neg Supply Voltage-Nom (Vsup) | -15V |
| Turn-Off Delay Time | 300 ns |
| Max Dual Supply Voltage | 20V |
| On-State Resistance (Max) | 100Ohm |
| Min Dual Supply Voltage | 5V |
| Multiplexer/Demultiplexer Circuit | 4:1 |
| Off-state Isolation-Nom | 75 dB |
| Current - Leakage (IS(off)) (Max) | 750pA |
| Channel Capacitance (CS(off), CD(off)) | 3pF 26pF |
| On-state Resistance Match-Nom | 1.5Ohm |
| Switch Circuit | SP4T |
| Switch Time (Ton, Toff) (Max) | 150ns, 150ns |
| Charge Injection | 2pC |
| Channel-to-Channel Matching (ΔRon) | 1.5 Ω |
| Crosstalk | -92dB @ 100kHz |
| Switching | BREAK-BEFORE-MAKE |
| Switch-on Time-Max | 150ns |
| Switch-off Time-Max | 150ns |
| Signal Current-Max | 0.03A |
| Height Seated (Max) | 1.1mm |
| Length | 5mm |
| Width | 4.4mm |
| Radiation Hardening | No |
| REACH SVHC | Unknown |
| RoHS Status | ROHS3 Compliant |
| Lead Free | Lead Free |
MAX309CUE+ Overview
The electronic component is convenient to ship overseas because it is packed in a 16-TSSOP (0.173, 4.40mm Width). High reliability is provided by advanced packaging method Tube. The multiplexer is located in Surface Mount. The ratio between the number of multiplexer and demultiplexer circuits is 4:1. Around 0°C~70°C TA is the extended operating temperature. The total number of terminations is 16. The electronic part provides high-quality output because it has 4 channels. Powered by a 15V voltage supply, the electrical part should be switched on and run. There are 16 pins injected into the electronic part body. Based on SP4T switching circuits, these analog multiplexers work. This multiplexer is composed of 2 circuits. Try searching for MAX309 variants of the analog switch ic. In this multiplexer, the internal resistance is 175Ohm. For details about the functions of 16 pins, please refer to the datasheets. An abnormal situation would be for the switch device to be supplied with a voltage greater than 30V. Dual, Single supply type digital switch with a low cost. It is recommended to use 5V as the lowest voltage for the electrical part. This multiplexer would work with 500μA current. For this switch device, it is feasible to have two supplies. However, the voltage should not exceed 20V. The voltage should be at least 5V if you are using dual power supplies. A voltage of 28V can be used to operate the electronic component.
MAX309CUE+ Features
4 Channels
Switch Circuit: SP4T
500μA Supply Current
MAX309CUE+ Applications
There are a lot of Maxim Integrated MAX309CUE+ Analog Switches & Multiplexers ICs applications.
- Microprocessor controlled systems
- Digital access cross connects
- DSUs
- Microwave transmission systems
- E1 Network Equipment
- Frame Relay Equipment
- Cable Modem
- Cellular phones
- E1 Multiplexer
- SONET
