MAX312CUE+T
| Parameters | |
|---|---|
| Factory Lead Time | 1 Week |
| Mount | Surface Mount |
| Mounting Type | Surface Mount |
| Package / Case | 16-TSSOP (0.173, 4.40mm Width) |
| Number of Pins | 16 |
| Operating Temperature | 0°C~70°C TA |
| Packaging | Tape & Reel (TR) |
| Published | 2007 |
| JESD-609 Code | e3 |
| Pbfree Code | yes |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Number of Terminations | 16 |
| ECCN Code | EAR99 |
| Resistance | 10Ohm |
| Terminal Finish | Matte Tin (Sn) |
| Subcategory | Multiplexer or Switches |
| Max Power Dissipation | 842mW |
| Technology | CMOS |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | 260 |
| Number of Functions | 4 |
| Supply Voltage | 15V |
| Terminal Pitch | 0.65mm |
| Time@Peak Reflow Temperature-Max (s) | 30 |
| Base Part Number | MAX312 |
| Output | SEPARATE OUTPUT |
| Pin Count | 16 |
| Operating Supply Voltage | 28V |
| Power Supplies | 512/+-15V |
| Number of Channels | 1 |
| Number of Circuits | 4 |
| Max Supply Voltage | 30V |
| Min Supply Voltage | 4.5V |
| Nominal Supply Current | 5μA |
| Max Supply Current | 1μA |
| Throw Configuration | SPST |
| Turn On Delay Time | 275 ns |
| Voltage - Supply, Single/Dual (±) | 4.5V~30V ±4.5V~20V |
| Supply Type | Dual, Single |
| Neg Supply Voltage-Nom (Vsup) | -15V |
| Turn-Off Delay Time | 235 ns |
| Max Dual Supply Voltage | 20V |
| On-State Resistance (Max) | 10Ohm |
| Min Dual Supply Voltage | 4.5V |
| Multiplexer/Demultiplexer Circuit | 1:1 |
| Off-state Isolation-Nom | 65 dB |
| Current - Leakage (IS(off)) (Max) | 500pA |
| Channel Capacitance (CS(off), CD(off)) | 15pF 15pF |
| On-state Resistance Match-Nom | 0.3Ohm |
| Switch Circuit | SPST - NC |
| Switch Time (Ton, Toff) (Max) | 225ns, 185ns |
| Charge Injection | 20pC |
| Channel-to-Channel Matching (ΔRon) | 300m Ω |
| Crosstalk | -85dB @ 1MHz |
| Switching | BREAK-BEFORE-MAKE |
| Switch-on Time-Max | 225ns |
| Switch-off Time-Max | 185ns |
| Normal Position | NO |
| Height Seated (Max) | 1.1mm |
| Length | 5mm |
| Radiation Hardening | No |
| RoHS Status | ROHS3 Compliant |
| Lead Free | Lead Free |
MAX312CUE+T Overview
Presented in 16-TSSOP (0.173, 4.40mm Width), this electrical component is convenient for overseas shipping. In order to provide high reliability, an advanced packaging method Tape & Reel (TR) is used. In Surface Mount, you'll find this switch device. Multiplexers and demultiplexers have the same number of circuits 1:1. Operating temperature extended to 0°C~70°C TA. Total terminations are 16. A electrical component with 1 channels is capable of high-quality output. An 15V voltage supply should allow the electrical part to be turned on and run. Electronic part bodies are injected with 16 pins. The analog switch ics are built using SPST - NC switching circuits. A 4 circuit is present in this switch device. Try searching for MAX312 variants of the analog switch ic. There is 10Ohm internal resistance in this digital multiplexer. To find out what the 16 pins do, please refer to the datasheets. The analogue multiplexer in this example is a typical Multiplexer or Switches. In normalcircumstances, users should not exceed 30V volts for the multiplexer. Analogue multiplexer with a Dual, Single supply type that is cost-effective. There should be 4.5V voltage fed to the electrical part below 4.5V. When the digital multiplexer is charged above 1μA, damage can occur. If put voltage greater than 20V on the multiplexer, damage may be caused to the device. You should attach at least 4.5V voltage if you are using dual power supply. SEPARATE OUTPUT outputs are utilized by this digital multiplexer. 28V operating voltages can be used with this electrical part.
MAX312CUE+T Features
1 Channels
Switch Circuit: SPST - NC
MAX312CUE+T Applications
There are a lot of Maxim Integrated MAX312CUE+T Analog Switches & Multiplexers ICs applications.
- Public switching systems
- Microprocessor controlled systems
- USB 1.1 signal switching circuits
- Battery Powered Systems
- ADCs such as AD7840/8, AD7870/1/2/4/5/6/8
- Data Acquisition Systems
- Fiber In The Loop (FITL)
- Digital cross connects (DSX-1)
- Industrial and process control systems
- Fault Tolerant Systems
