Parameters |
Factory Lead Time |
1 Week |
Contact Plating |
Tin |
Mount |
Surface Mount |
Mounting Type |
Surface Mount |
Package / Case |
16-SOIC (0.154, 3.90mm Width) |
Operating Temperature |
0°C~70°C TA |
Packaging |
Tape & Reel (TR) |
Published |
2001 |
JESD-609 Code |
e3 |
Pbfree Code |
yes |
Part Status |
Active |
Moisture Sensitivity Level (MSL) |
1 (Unlimited) |
Number of Terminations |
16 |
ECCN Code |
EAR99 |
Resistance |
10Ohm |
Terminal Finish |
TIN |
Subcategory |
Multiplexer or Switches |
Max Power Dissipation |
842mW |
Technology |
CMOS |
Terminal Form |
GULL WING |
Peak Reflow Temperature (Cel) |
260 |
Number of Functions |
4 |
Supply Voltage |
15V |
Terminal Pitch |
1.27mm |
Base Part Number |
MAX312 |
Pin Count |
16 |
JESD-30 Code |
R-PDSO-G16 |
Operating Supply Voltage |
18V |
Polarity |
Non-Inverting |
Number of Channels |
1 |
Number of Circuits |
4 |
Max Supply Voltage |
30V |
Min Supply Voltage |
4.5V |
Nominal Supply Current |
5μA |
Max Supply Current |
200μA |
Throw Configuration |
SPST |
Turn On Delay Time |
275 ns |
Voltage - Supply, Single/Dual (±) |
4.5V~36V ±4.5V~20V |
Supply Type |
Dual, Single |
Neg Supply Voltage-Nom (Vsup) |
-15V |
Turn-Off Delay Time |
235 ns |
Max Dual Supply Voltage |
20V |
On-State Resistance (Max) |
10Ohm |
Min Dual Supply Voltage |
4.5V |
High Level Output Current |
100mA |
Multiplexer/Demultiplexer Circuit |
1:1 |
Off-state Isolation-Nom |
75 dB |
Current - Leakage (IS(off)) (Max) |
500pA |
Channel Capacitance (CS(off), CD(off)) |
15pF 15pF |
On-state Resistance Match-Nom |
0.3Ohm |
Switch Circuit |
SPST - NC |
Switch Time (Ton, Toff) (Max) |
225ns, 185ns |
Charge Injection |
20pC |
Channel-to-Channel Matching (ΔRon) |
300m Ω |
Crosstalk |
-85dB @ 1MHz |
Switching |
BREAK-BEFORE-MAKE |
Switch-on Time-Max |
225ns |
Switch-off Time-Max |
185ns |
Normal Position |
NC |
Height Seated (Max) |
1.75mm |
Length |
9.9mm |
Width |
3.9mm |
Radiation Hardening |
No |
RoHS Status |
ROHS3 Compliant |
Lead Free |
Lead Free |
MAX312LCSE+T Overview
Presented in 16-SOIC (0.154, 3.90mm Width), this electrical component is convenient for overseas shipping. High reliability is ensured by the advanced packaging method Tape & Reel (TR). This analog switch is mounted in Surface Mount. Multiplexers and demultiplexers have a number of circuits 1:1. Operating temperature extended to 0°C~70°C TA. In total, there have been 16 terminations. The electronic part provides high-quality output because it has 1 channels. A 15V voltage supply should turn on and run the electronic component. A total of 16 pins are injected into the electrical part body. Unlike digital switches, these are based on SPST - NC switching circuits. There are 4 circuits in this switch device. MAX312 can be used to search for analog multiplexer variants. In this multiplexer, the internal resistance is 10Ohm. A analogue multiplexer of this type is a Multiplexer or Switches. It is normally recommended that users do not supply the multiplexer with voltages higher than 30V. Dual, Single supply type digital switch with a low cost. 4.5V is the lowest voltage the electrical component should receive. The switch multiplexer may be damaged if it is exposed to voltage greater than 200μA. For this switch, a dual supply voltage is feasible, but it must not exceed 20VWith dual power supplies, you should attach at least 4.5V. There is a voltage range of 18V operating voltages for the electrical part.
MAX312LCSE+T Features
1 Channels
Switch Circuit: SPST - NC
MAX312LCSE+T Applications
There are a lot of Maxim Integrated MAX312LCSE+T Analog Switches & Multiplexers ICs applications.
- Modems
- Public switching systems
- Switching Systems
- Digital access cross connects
- Intelligent PBX
- ATM
- Private Branch Exchange (PBX)
- Fault Tolerant Systems
- Remote Powered Equipment
- Digital cross connects (DSX-1)