MAX313FESE+

225ns, 185ns SPST - NO 10Ohm Analog Switches BREAK-BEFORE-MAKE MAX313 16 Pins 1μA 15V 16-SOIC (0.154, 3.90mm Width)

Manufacturer: Maxim Integrated
Nocochips NO: 503-MAX313FESE+
Package: 16-SOIC (0.154, 3.90mm Width)
Datasheet: PDF
Stock: 228
Description: 225ns, 185ns SPST - NO 10Ohm Analog Switches BREAK-BEFORE-MAKE MAX313 16 Pins 1μA 15V 16-SOIC (0.154, 3.90mm Width)(Kg)

Details

Tags

Parameters
Factory Lead Time	1 Week
Mount	Surface Mount
Mounting Type	Surface Mount
Package / Case	16-SOIC (0.154, 3.90mm Width)
Number of Pins	16
Operating Temperature	-40°C~85°C TA
Packaging	Tube
Published	2003
JESD-609 Code	e3
Pbfree Code	yes
Part Status	Active
Moisture Sensitivity Level (MSL)	1 (Unlimited)
Number of Terminations	16
ECCN Code	EAR99
Resistance	10Ohm
Terminal Finish	Matte Tin (Sn)
Subcategory	Multiplexer or Switches
Max Power Dissipation	842mW
Technology	CMOS
Terminal Form	GULL WING
Peak Reflow Temperature (Cel)	260
Number of Functions	4
Supply Voltage	15V
Terminal Pitch	1.27mm
Time@Peak Reflow Temperature-Max (s)	30
Base Part Number	MAX313
Output	SEPARATE OUTPUT
Pin Count	16
Operating Supply Voltage	20V
Power Supplies	12/+-15V
Number of Channels	1
Number of Circuits	4
Max Supply Voltage	36V
Min Supply Voltage	9V
Nominal Supply Current	100pA
Max Supply Current	100pA
Throw Configuration	SPST
Turn On Delay Time	225 ns
Voltage - Supply, Single/Dual (±)	9V~36V ±4.5V~20V
Supply Type	Dual, Single
Neg Supply Voltage-Nom (Vsup)	-15V
Turn-Off Delay Time	185 ns
Max Dual Supply Voltage	20V
On-State Resistance (Max)	10Ohm
Min Dual Supply Voltage	4.5V
Multiplexer/Demultiplexer Circuit	1:1
Off-state Isolation-Nom	55 dB
Current - Leakage (IS(off)) (Max)	1μA
Channel Capacitance (CS(off), CD(off))	20pF 20pF
On-state Resistance Match-Nom	0.05Ohm
Switch Circuit	SPST - NO
Switch Time (Ton, Toff) (Max)	225ns, 185ns
Charge Injection	70pC
Channel-to-Channel Matching (ΔRon)	50m Ω
Crosstalk	-104dB @ 1MHz
Switching	BREAK-BEFORE-MAKE
Normal Position	NC
Height	1.5mm
Length	10mm
Width	4mm
Radiation Hardening	No
REACH SVHC	Unknown
RoHS Status	ROHS3 Compliant
Lead Free	Lead Free

MAX313FESE+ Overview

Due to its 16-SOIC (0.154, 3.90mm Width) packaging, the electronic part is convenient for international shipping. This packaging method provides high reliability because it uses advanced packaging techniques. The multiplexer is located in Surface Mount. Multiplexers and demultiplexers have a ratio of 1:1. Extended operating temperature around -40°C~85°C TA. There are 16 terminations totally. This electronic part offers high-quality output due to its 1 channels. When a voltage supply of 15V is used, the electronic component should be turned on and run. Into the electrical component body are injected 16 pins. Multiplexers built on a SPST - NO switching circuit are built. A 4 circuit is present in this switch device. Try searching for the analog switch ic with MAX313 if you are looking for variants. There is 10Ohm internal resistance in this digital multiplexer. Datasheets for 16 pin functions are available upon request. Theswitch device is a typical Multiplexer or Switches. normally, users should not supply switches with voltages higher than 36V. A analog switch ic that has a cost-effective Dual, Single supply type. The lowest voltage fed to the electronic component should be 9V. If you put voltage higher than 100pA on the digital multiplexer, damage may occur. It is possible to supply this switch device with dual voltages. However, it is not advisable to exceed 20V. It is recommended that you attach at least 4.5V to your dual power supply. A total of SEPARATE OUTPUT outputs are available on this analog switch ic. It can operate from 20V operating voltages.