Parameters |
Factory Lead Time |
1 Week |
Contact Plating |
Tin |
Mount |
Surface Mount |
Mounting Type |
Surface Mount |
Package / Case |
16-SOIC (0.154, 3.90mm Width) |
Number of Pins |
16 |
Operating Temperature |
0°C~70°C TA |
Packaging |
Tape & Reel (TR) |
Published |
2010 |
JESD-609 Code |
e3 |
Pbfree Code |
yes |
Part Status |
Active |
Moisture Sensitivity Level (MSL) |
1 (Unlimited) |
Number of Terminations |
16 |
ECCN Code |
EAR99 |
Resistance |
10Ohm |
Subcategory |
Multiplexer or Switches |
Max Power Dissipation |
842mW |
Technology |
CMOS |
Terminal Form |
GULL WING |
Peak Reflow Temperature (Cel) |
260 |
Number of Functions |
4 |
Supply Voltage |
15V |
Terminal Pitch |
1.27mm |
Time@Peak Reflow Temperature-Max (s) |
30 |
Base Part Number |
MAX314 |
Pin Count |
16 |
Operating Supply Voltage |
20V |
Polarity |
Non-Inverting |
Power Supplies |
512/+-15V |
Number of Channels |
1 |
Number of Circuits |
4 |
Max Supply Voltage |
30V |
Min Supply Voltage |
4.5V |
Nominal Supply Current |
5μA |
Max Supply Current |
100pA |
Throw Configuration |
SPST |
Turn On Delay Time |
275 ns |
Voltage - Supply, Single/Dual (±) |
4.5V~30V ±4.5V~20V |
Supply Type |
Dual, Single |
Neg Supply Voltage-Nom (Vsup) |
-15V |
Turn-Off Delay Time |
235 ns |
Max Dual Supply Voltage |
20V |
On-State Resistance (Max) |
10Ohm |
Min Dual Supply Voltage |
4.5V |
High Level Output Current |
100mA |
Multiplexer/Demultiplexer Circuit |
1:1 |
Off-state Isolation-Nom |
65 dB |
Current - Leakage (IS(off)) (Max) |
500pA |
Channel Capacitance (CS(off), CD(off)) |
15pF 15pF |
On-state Resistance Match-Nom |
0.3Ohm |
Switch Circuit |
SPST - NO/NC |
Switch Time (Ton, Toff) (Max) |
225ns, 185ns |
Charge Injection |
20pC |
Channel-to-Channel Matching (ΔRon) |
300m Ω |
Crosstalk |
-85dB @ 1MHz |
Switching |
BREAK-BEFORE-MAKE |
Switch-on Time-Max |
225ns |
Switch-off Time-Max |
185ns |
Height Seated (Max) |
1.75mm |
Length |
9.9mm |
Width |
3.9mm |
Radiation Hardening |
No |
RoHS Status |
ROHS3 Compliant |
Lead Free |
Lead Free |
MAX314CSE+T Overview
Packed in 16-SOIC (0.154, 3.90mm Width), the electronic component is convenient for shipping overseas. High reliability is ensured by the advanced packaging method Tape & Reel (TR). It is mounted in the position Surface Mount. 1:1 is the ratio of multiplexer to demultiplexer circuits. Extended operating temperature around 0°C~70°C TA. Total terminations are 16. The electronic part provides high-quality output because it has 1 channels. It is safe to turn on and run the electronic component with a 15V voltage supply. Electronic part bodies are injected with 16 pins. These analog multiplexers are built based on SPST - NO/NC switching circuits. It consists of 4 circuits. If you are looking for variants of the digital switch, trying search with MAX314. As far as internal resistance is concerned, it has 10Ohm. For details about the functions of 16 pins, please refer to the datasheets. It is a typical Multiplexer or Switches analog multiplexer. It is generally not recommended to supply a voltage higher than 30V to the switch device in normal circumstances. Analogue multiplexer with a Dual, Single supply type that is cost-effective. 4.5V is the lowest voltage the electrical component should receive. When the digital multiplexer is charged above 100pA, damage can occur. Dual supply volatge is feasible for this multiplexer. But it should not go beyond 20V. In the case of dual power supplies, you should connect at least 4.5V. 20V operating voltages are supported by the electronic component.
MAX314CSE+T Features
1 Channels
Switch Circuit: SPST - NO/NC
MAX314CSE+T Applications
There are a lot of Maxim Integrated MAX314CSE+T Analog Switches & Multiplexers ICs applications.
- Data Acquisition Systems
- ATM
- USB 1.1 signal switching circuits
- Avionics and Military Systems
- Private Branch Exchange (PBX)
- Isolation
- Short/Medium Loop: approximately 2000 ft. of 26 AWG and 5 REN loads
- Medical systems
- SDH/SONET multiplexers
- Cellular phones