Parameters |
Mount |
Through Hole |
Mounting Type |
Through Hole |
Package / Case |
16-DIP (0.300, 7.62mm) |
Number of Pins |
16 |
Operating Temperature |
-40°C~85°C TA |
Packaging |
Tube |
Published |
2003 |
JESD-609 Code |
e3 |
Pbfree Code |
yes |
Part Status |
Obsolete |
Moisture Sensitivity Level (MSL) |
1 (Unlimited) |
Number of Terminations |
16 |
ECCN Code |
EAR99 |
Resistance |
10Ohm |
Terminal Finish |
Matte Tin (Sn) |
Max Power Dissipation |
842mW |
Technology |
CMOS |
Peak Reflow Temperature (Cel) |
260 |
Number of Functions |
4 |
Supply Voltage |
15V |
Base Part Number |
MAX314 |
Pin Count |
16 |
Operating Supply Voltage |
18V |
Number of Channels |
1 |
Number of Circuits |
4 |
Max Supply Voltage |
30V |
Min Supply Voltage |
4.5V |
Nominal Supply Current |
5μA |
Max Supply Current |
500μA |
Throw Configuration |
SPST |
Turn On Delay Time |
275 ns |
Voltage - Supply, Single/Dual (±) |
9V~36V ±4.5V~20V |
Supply Type |
Dual, Single |
Neg Supply Voltage-Nom (Vsup) |
-15V |
Turn-Off Delay Time |
235 ns |
Max Dual Supply Voltage |
20V |
On-State Resistance (Max) |
10Ohm |
Min Dual Supply Voltage |
4.5V |
Multiplexer/Demultiplexer Circuit |
1:1 |
Off-state Isolation-Nom |
55 dB |
Current - Leakage (IS(off)) (Max) |
1nA |
Channel Capacitance (CS(off), CD(off)) |
20pF 20pF |
On-state Resistance Match-Nom |
0.05Ohm |
Switch Circuit |
SPST - NO/NC |
Switch Time (Ton, Toff) (Max) |
225ns, 185ns |
Charge Injection |
70pC |
Channel-to-Channel Matching (ΔRon) |
50m Ω |
Crosstalk |
-104dB @ 1MHz |
Switch-on Time-Max |
225ns |
Switch-off Time-Max |
185ns |
Length |
19.175mm |
Width |
7.62mm |
Radiation Hardening |
No |
RoHS Status |
ROHS3 Compliant |
Lead Free |
Lead Free |
MAX314FEPE+ Overview
Shipping overseas is convenient with the electronic component packed in 16-DIP (0.300, 7.62mm). Advanced packaging method Tube is used to provide high reliability. It is mounted in the position Through Hole. Multiplexer and demultiplexer circuits have a number 1:1. Operational temperature extended around -40°C~85°C TA. There are 16 terminations totally. This electronic part offers high-quality output due to its 1 channels. When a voltage supply of 15V is used, the electronic component should be turned on and run. An electrical component like this is included in the 16 series. A SPST - NO/NC switching circuit is used to build these analog multiplexers. There are 4 circuits in this switch device. If you are looking for variants of the digital switch, trying search with MAX314. Internally, this switch multiplexer has a resistance of 10Ohm. Datasheets for 16 pin functions are available upon request. A voltage higher than 30V should not normally be supplied to the switches. Dual, Single supply type digital switch with a low cost. 4.5V is the lowest voltage the electrical component should receive. When the digital multiplexer is charged above 500μA, damage can occur. For this switch, a dual supply voltage is feasible, but it must not exceed 20VIf you are using dual power supplies, you should attach at least 4.5V. It can operate from 18V operating voltages.
MAX314FEPE+ Features
1 Channels
Switch Circuit: SPST - NO/NC
MAX314FEPE+ Applications
There are a lot of Maxim Integrated MAX314FEPE+ Analog Switches & Multiplexers ICs applications.
- Audio and video routing
- Video signal routing
- DSLAMs
- Channel Banks
- ISDN NT1/TA
- Avionics and Military Systems
- Public switching systems
- Switching Systems
- USB 1.1 signal switching circuits
- Voice over IP/DSL – Integrated Access Devices, Smart