Parameters |
Mount |
Surface Mount |
Mounting Type |
Surface Mount |
Package / Case |
16-TSSOP (0.173, 4.40mm Width) |
Number of Pins |
16 |
Operating Temperature |
0°C~70°C TA |
Packaging |
Tape & Reel (TR) |
Published |
2009 |
JESD-609 Code |
e3 |
Pbfree Code |
yes |
Part Status |
Active |
Moisture Sensitivity Level (MSL) |
1 (Unlimited) |
Number of Terminations |
16 |
ECCN Code |
EAR99 |
Resistance |
10Ohm |
Terminal Finish |
TIN |
Subcategory |
Multiplexer or Switches |
Max Power Dissipation |
842mW |
Technology |
CMOS |
Terminal Form |
GULL WING |
Peak Reflow Temperature (Cel) |
260 |
Number of Functions |
4 |
Supply Voltage |
15V |
Terminal Pitch |
0.65mm |
Time@Peak Reflow Temperature-Max (s) |
30 |
Base Part Number |
MAX314 |
Output |
SEPARATE OUTPUT |
Pin Count |
16 |
Operating Supply Voltage |
18V |
Number of Channels |
1 |
Number of Circuits |
4 |
Max Supply Voltage |
30V |
Min Supply Voltage |
4.5V |
Nominal Supply Current |
5μA |
Max Supply Current |
200μA |
Throw Configuration |
SPST |
Turn On Delay Time |
275 ns |
Voltage - Supply, Single/Dual (±) |
4.5V~36V ±4.5V~20V |
Supply Type |
Dual, Single |
Neg Supply Voltage-Nom (Vsup) |
-15V |
Turn-Off Delay Time |
235 ns |
Max Dual Supply Voltage |
20V |
On-State Resistance (Max) |
10Ohm |
Min Dual Supply Voltage |
4.5V |
Multiplexer/Demultiplexer Circuit |
1:1 |
Off-state Isolation-Nom |
75 dB |
Current - Leakage (IS(off)) (Max) |
500pA |
Channel Capacitance (CS(off), CD(off)) |
15pF 15pF |
On-state Resistance Match-Nom |
0.3Ohm |
Switch Circuit |
SPST - NO/NC |
Switch Time (Ton, Toff) (Max) |
225ns, 185ns |
Charge Injection |
20pC |
Channel-to-Channel Matching (ΔRon) |
300m Ω |
Crosstalk |
-85dB @ 1MHz |
Switching |
BREAK-BEFORE-MAKE |
Switch-on Time-Max |
225ns |
Switch-off Time-Max |
185ns |
Height Seated (Max) |
1.1mm |
Length |
5mm |
Radiation Hardening |
No |
RoHS Status |
ROHS3 Compliant |
Lead Free |
Lead Free |
MAX314LCUE+T Overview
Packed in 16-TSSOP (0.173, 4.40mm Width), the electronic component is convenient for shipping overseas. This high-reliability packaging method uses advanced packaging methods Tape & Reel (TR). This analog switch is mounted in Surface Mount. Multiplexers and demultiplexers have a number of circuits 1:1. The operating temperature is extended to around 0°C~70°C TA. A total of 16 terminations have been recorded. As a result of its 1 channels, this electronic component provides high-quality output. Powered by a 15V voltage supply, the electrical part should be switched on and run. An electrical component of this type can be found in the 16 series. Based on SPST - NO/NC switching circuits, these analog multiplexers work. There are 4 circuits in this switch device. Try searching with MAX314 to find analog multiplexer variants. Internally, this switch multiplexer has a resistance of 10Ohm. Datasheets for functions of 16 pins are available. There is Multiplexer or Switches analog multiplexer like this in the world. In normalcircumstances, users should not exceed 30V volts for the multiplexer. Analogue multiplexers of the Dual, Single supply type that are cost-effective. The lowest voltage the electronic part should receive is 4.5V. When the digital multiplexer is charged above 200μA, damage can occur. For this switch device, it is feasible to have two supplies. However, the voltage should not exceed 20V. If you are using a dual power supply, you should attach at least 4.5V. The digital multiplexer has SEPARATE OUTPUT outputs that can be used. This electrical part is compatible with 18V operating voltages.
MAX314LCUE+T Features
1 Channels
Switch Circuit: SPST - NO/NC
MAX314LCUE+T Applications
There are a lot of Maxim Integrated MAX314LCUE+T Analog Switches & Multiplexers ICs applications.
- Channel Banks
- Channelized and Unchannelized DS3 applications
- Fault Tolerant Systems
- Private Branch Exchange (PBX)
- Audio and video signal routing
- SONET
- Digital access cross connects
- Communication systems
- Battery Powered Instruments
- PBXs