MAX317CSA+
| Parameters | |
|---|---|
| Width | 3.9mm |
| Radiation Hardening | No |
| RoHS Status | ROHS3 Compliant |
| Lead Free | Lead Free |
| Factory Lead Time | 1 Week |
| Mount | Surface Mount |
| Mounting Type | Surface Mount |
| Package / Case | 8-SOIC (0.154, 3.90mm Width) |
| Number of Pins | 8 |
| Operating Temperature | 0°C~70°C TA |
| Packaging | Tube |
| Published | 1995 |
| JESD-609 Code | e3 |
| Pbfree Code | yes |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Number of Terminations | 8 |
| ECCN Code | EAR99 |
| Resistance | 35Ohm |
| Terminal Finish | Matte Tin (Sn) |
| Subcategory | Multiplexer or Switches |
| Max Power Dissipation | 727mW |
| Technology | CMOS |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | 260 |
| Number of Functions | 1 |
| Supply Voltage | 15V |
| Time@Peak Reflow Temperature-Max (s) | 30 |
| Base Part Number | MAX317 |
| Pin Count | 8 |
| Operating Supply Voltage | 20V |
| Number of Channels | 1 |
| Number of Circuits | 1 |
| Max Supply Voltage | 30V |
| Min Supply Voltage | 10V |
| Operating Supply Current | 1μA |
| Nominal Supply Current | 5μA |
| Max Supply Current | 1μA |
| Throw Configuration | SPST |
| Turn On Delay Time | 145 ns |
| Voltage - Supply, Single/Dual (±) | 10V~30V ±4.5V~20V |
| Supply Type | Dual, Single |
| Neg Supply Voltage-Nom (Vsup) | -15V |
| Turn-Off Delay Time | 175 ns |
| Max Dual Supply Voltage | 20V |
| On-State Resistance (Max) | 35Ohm |
| Min Dual Supply Voltage | 4.5V |
| Multiplexer/Demultiplexer Circuit | 1:1 |
| Off-state Isolation-Nom | 68 dB |
| Current - Leakage (IS(off)) (Max) | 250pA |
| Channel Capacitance (CS(off), CD(off)) | 8pF 8pF |
| On-state Resistance Match-Nom | 2Ohm |
| Switch Circuit | SPST - NC |
| Switch Time (Ton, Toff) (Max) | 175ns, 145ns |
| Charge Injection | 3pC |
| Channel-to-Channel Matching (ΔRon) | 2 Ω (Max) |
| Crosstalk | -85dB @ 1MHz |
| Switching | BREAK-BEFORE-MAKE |
| Normal Position | NC |
| Length | 4.9mm |
MAX317CSA+ Overview
The electronic component is convenient to ship overseas because it is packed in a 8-SOIC (0.154, 3.90mm Width). A high level of reliability can be achieved through the use of an advanced packaging method Tube. The multiplexer is located in Surface Mount. Multiplexer and demultiplexer circuits have a number 1:1. Around 0°C~70°C TA is the extended operating temperature. In total, 8 terminations have occurred. The electronic part delivers high-quality output through its 1 channels. A 15V voltage supply should turn on and run the electronic component. An electrical component of this type can be found in the 8 series. Unlike digital switches, these are based on SPST - NC switching circuits. A total of 1 circuits make up this switch device. Try searching for the analog switch ic with MAX317 if you are looking for variants. The internal resistance of this digital multiplexer is 35Ohm. For functions related to 8 pins, please refer to the datasheets. It is a typical Multiplexer or Switches analog multiplexer. Users shouldn't supply more than 30V voltage to the switch device. Analogue multiplexer with a Dual, Single supply type that is cost-effective. The lowest voltage fed to the electronic component should be 10V. For this digital switch to work, 1μA current would suffice. A voltage higher than 1μA may cause damage to the switch multiplexer. Dual supply volatge is feasible for this multiplexer. But it should not go beyond 20V. For dual power supplies, a voltage of at least 4.5V should be attached. The electronic component can function from 20V.
MAX317CSA+ Features
1 Channels
Switch Circuit: SPST - NC
1μA Supply Current
MAX317CSA+ Applications
There are a lot of Maxim Integrated MAX317CSA+ Analog Switches & Multiplexers ICs applications.
- Digital Cross-Connects
- Industrial
- Automatic test equipment
- Data switching
- Power routing
- Avionics and Military Systems
- Digital access cross connects
- Cellular phones
- Medical systems
- Fiber to the Home
