MAX320CUA+

150ns, 100ns SPST - NO 35Ohm Analog Switches BREAK-BEFORE-MAKE MAX320 8 Pins 100pA 5V 8-TSSOP, 8-MSOP (0.118, 3.00mm Width)

Manufacturer: Maxim Integrated
Nocochips NO: 503-MAX320CUA+
Package: 8-TSSOP, 8-MSOP (0.118, 3.00mm Width)
Datasheet: PDF
Stock: 883
Description: 150ns, 100ns SPST - NO 35Ohm Analog Switches BREAK-BEFORE-MAKE MAX320 8 Pins 100pA 5V 8-TSSOP, 8-MSOP (0.118, 3.00mm Width)(Kg)

Inquiry Now

Details

Tags

Parameters
Factory Lead Time	1 Week
Mount	Surface Mount
Mounting Type	Surface Mount
Package / Case	8-TSSOP, 8-MSOP (0.118, 3.00mm Width)
Number of Pins	8
Operating Temperature	0°C~70°C TA
Packaging	Tube
Published	1995
JESD-609 Code	e3
Pbfree Code	yes
Part Status	Active
Moisture Sensitivity Level (MSL)	1 (Unlimited)
Number of Terminations	8
ECCN Code	EAR99
Resistance	35Ohm
Terminal Finish	Matte Tin (Sn)
Subcategory	Multiplexer or Switches
Max Power Dissipation	471mW
Technology	CMOS
Terminal Form	GULL WING
Peak Reflow Temperature (Cel)	260
Number of Functions	2
Supply Voltage	5V
Terminal Pitch	0.65mm
Time@Peak Reflow Temperature-Max (s)	30
Base Part Number	MAX320
Output	SEPARATE OUTPUT
Pin Count	8
Operating Supply Voltage	5V
Number of Channels	1
Number of Circuits	2
Max Supply Voltage	8V
Min Supply Voltage	2.7V
Operating Supply Current	1μA
Nominal Supply Current	80μA
Max Supply Current	125μA
Throw Configuration	SPST
Turn On Delay Time	175 ns
Supply Type	Dual
Neg Supply Voltage-Nom (Vsup)	-5V
Turn-Off Delay Time	150 ns
Max Dual Supply Voltage	8V
On-State Resistance (Max)	35Ohm
Min Dual Supply Voltage	2.7V
Multiplexer/Demultiplexer Circuit	1:1
Off-state Isolation-Nom	72 dB
Current - Leakage (IS(off)) (Max)	100pA
Channel Capacitance (CS(off), CD(off))	9pF 9pF
On-state Resistance Match-Nom	0.3Ohm
Switch Circuit	SPST - NO
Switch Time (Ton, Toff) (Max)	150ns, 100ns
Charge Injection	2pC
Channel-to-Channel Matching (ΔRon)	300m Ω
Crosstalk	-85dB @ 1MHz
Switching	BREAK-BEFORE-MAKE
Switch-off Time-Max	100ns
Normal Position	NO
Voltage - Supply, Dual (V±)	±2.7V~8V
Height	910μm
Length	3.05mm
Width	3.05mm
Radiation Hardening	No
REACH SVHC	Unknown
RoHS Status	ROHS3 Compliant
Lead Free	Lead Free

MAX320CUA+ Overview

Presented in 8-TSSOP, 8-MSOP (0.118, 3.00mm Width), this electrical component is convenient for overseas shipping. This packaging method provides high reliability because it uses advanced packaging techniques. Surface Mount is where this multiplexer is located. 1:1 is the ratio between multiplexers and demultiplexers. Extended operating temperature around 0°C~70°C TA. The total number of terminations is 8. A electrical component with 1 channels is capable of high-quality output. With a 5V voltage supply, the electrical component should be turned on and run. It is part of the design of the 8 series that this electronic component is included. A SPST - NO switching circuit is used to build these analog multiplexers. 2 circuits are used in this analogue multiplexer. Try searching with MAX320 to find analog multiplexer variants. This digital multiplexer has 35Ohm internal resistance. You can find the functions of the 8 pins in the datasheets. Theswitch device is a typical Multiplexer or Switches. A voltage higher than 8V should not normally be supplied to the switches. Analogue multiplexer with a Dual supply type that is cost-effective. It is recommended to use 2.7V as the lowest voltage for the electrical part. The analogue multiplexer could operate on 1μA current. When the digital multiplexer is charged above 125μA, damage can occur. There's no problem with dual supply voltage for this switch device. However, it shouldn't exceed 8V. If you are using a dual power supply, you should attach at least 2.7V. There are SEPARATE OUTPUT outputs on this analog switch ic. Operating voltages of 5V are compatible with the electrical part.