MAX322ESA+
| Parameters | |
|---|---|
| Factory Lead Time | 1 Week |
| Mount | Surface Mount |
| Mounting Type | Surface Mount |
| Package / Case | 8-SOIC (0.154, 3.90mm Width) |
| Number of Pins | 8 |
| Operating Temperature | -40°C~85°C TA |
| Packaging | Tube |
| Published | 1995 |
| JESD-609 Code | e3 |
| Pbfree Code | yes |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Number of Terminations | 8 |
| ECCN Code | EAR99 |
| Resistance | 35Ohm |
| Terminal Finish | Matte Tin (Sn) |
| Subcategory | Multiplexer or Switches |
| Max Power Dissipation | 471mW |
| Technology | CMOS |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | 260 |
| Number of Functions | 2 |
| Supply Voltage | 5V |
| Time@Peak Reflow Temperature-Max (s) | 30 |
| Base Part Number | MAX322 |
| Output | SEPARATE OUTPUT |
| Pin Count | 8 |
| Power Supplies | +-5V |
| Number of Channels | 1 |
| Number of Circuits | 2 |
| Max Supply Voltage | 8V |
| Min Supply Voltage | 2.7V |
| Operating Supply Current | 1μA |
| Nominal Supply Current | 80μA |
| Max Supply Current | 125μA |
| Throw Configuration | SPST |
| Turn On Delay Time | 150 ns |
| Supply Type | Dual |
| Neg Supply Voltage-Nom (Vsup) | -5V |
| Turn-Off Delay Time | 100 ns |
| Max Dual Supply Voltage | 8V |
| On-State Resistance (Max) | 35Ohm |
| Min Dual Supply Voltage | 2.7V |
| Multiplexer/Demultiplexer Circuit | 1:1 |
| Off-state Isolation-Nom | 72 dB |
| Current - Leakage (IS(off)) (Max) | 100pA |
| Channel Capacitance (CS(off), CD(off)) | 9pF 9pF |
| On-state Resistance Match-Nom | 0.3Ohm |
| Switch Circuit | SPST - NO/NC |
| Switch Time (Ton, Toff) (Max) | 150ns, 100ns |
| Charge Injection | 2pC |
| Channel-to-Channel Matching (ΔRon) | 300m Ω |
| Crosstalk | -85dB @ 1MHz |
| Switching | BREAK-BEFORE-MAKE |
| Voltage - Supply, Dual (V±) | ±2.7V~8V |
| Height Seated (Max) | 1.75mm |
| Length | 4.9mm |
| Width | 3.9mm |
| Radiation Hardening | No |
| RoHS Status | ROHS3 Compliant |
| Lead Free | Lead Free |
MAX322ESA+ Overview
The electronic part can be shipped overseas conveniently because it is packaged in 8-SOIC (0.154, 3.90mm Width). In order to provide high reliability, an advanced packaging method Tube is used. A switch device like this is mounted in Surface Mount. Multiplexer and demultiplexer circuits have a number 1:1. Extended operating temperature around -40°C~85°C TA. In total, there have been 8 terminations. As a result of its 1 channels, this electronic component provides high-quality output. When the electronic component is given a voltage of 5V, it should be turned on and run. An electrical component like this is included in the 8 series. Based on SPST - NO/NC switching circuits, these analog multiplexers work. There are 2 circuits in this multiplexer. Try searching with MAX322 to find analog multiplexer variants. In this multiplexer, the internal resistance is 35Ohm. Please refer to the datasheets for 8 pins functions. It is a typical Multiplexer or Switches analog multiplexer. normally, users should not supply switches with voltages higher than 8V. Analog switch ics with Dual supply type are cost-effective. The lowest voltage fed to the electronic component should be 2.7V. For this digital switch to work, 1μA current would suffice. Putting voltage greater than 125μA on the multiplexer may cause damage. For this switch, a dual supply voltage is feasible, but it must not exceed 8VWhen using dual power supplies, you should attach at least 2.7V. There are SEPARATE OUTPUT outputs on this analog switch ic.
MAX322ESA+ Features
1 Channels
Switch Circuit: SPST - NO/NC
1μA Supply Current
MAX322ESA+ Applications
There are a lot of Maxim Integrated MAX322ESA+ Analog Switches & Multiplexers ICs applications.
- PDH Multiplexers
- SONET
- Mechanical reed relay replacement
- Microprocessor Controlled Analog Systems
- Optical Applications
- Audio and video routing
- Industrial
- Relay replacements
- Digital Cross-Connects
- Relay Replacement
