MAX323CSA+
| Parameters | |
|---|---|
| Factory Lead Time | 1 Week |
| Mount | Surface Mount |
| Mounting Type | Surface Mount |
| Package / Case | 8-SOIC (0.154, 3.90mm Width) |
| Number of Pins | 8 |
| Operating Temperature | 0°C~70°C TA |
| Packaging | Tube |
| Published | 1998 |
| JESD-609 Code | e3 |
| Pbfree Code | yes |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Number of Terminations | 8 |
| ECCN Code | EAR99 |
| Resistance | 60Ohm |
| Terminal Finish | Matte Tin (Sn) |
| Subcategory | Multiplexer or Switches |
| Max Power Dissipation | 471mW |
| Technology | CMOS |
| Terminal Position | DUAL |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | 260 |
| Number of Functions | 2 |
| Supply Voltage | 5V |
| Time@Peak Reflow Temperature-Max (s) | 30 |
| Base Part Number | MAX323 |
| Output | SEPARATE OUTPUT |
| Pin Count | 8 |
| Power Supplies | 3.3/5V |
| Number of Channels | 1 |
| Number of Circuits | 2 |
| Max Supply Voltage | 16V |
| Min Supply Voltage | 2.7V |
| Operating Supply Current | 1μA |
| Nominal Supply Current | 100pA |
| Max Supply Current | 100pA |
| Throw Configuration | SPST |
| Turn On Delay Time | 150 ns |
| Supply Type | Single |
| Turn-Off Delay Time | 100 ns |
| On-State Resistance (Max) | 60Ohm |
| Multiplexer/Demultiplexer Circuit | 1:1 |
| Off-state Isolation-Nom | 72 dB |
| Channel Capacitance (CS(off), CD(off)) | 9pF 9pF |
| On-state Resistance Match-Nom | 0.8Ohm |
| Switch Circuit | SPST - NO |
| Switch Time (Ton, Toff) (Max) | 150ns, 100ns |
| Charge Injection | 1pC |
| Channel-to-Channel Matching (ΔRon) | 800m Ω |
| Crosstalk | -85dB @ 1MHz |
| Switching | BREAK-BEFORE-MAKE |
| Voltage - Supply, Single (V+) | 2.7V~16V |
| Drain to Source Resistance | 33mOhm |
| Normal Position | NO |
| Height | 1.5mm |
| Length | 5mm |
| Width | 4mm |
| Radiation Hardening | No |
| RoHS Status | ROHS3 Compliant |
| Lead Free | Lead Free |
MAX323CSA+ Overview
As the electronic part is packed in 8-SOIC (0.154, 3.90mm Width), international shipping is convenient. Advanced packaging method Tube is used to provide high reliability. In Surface Mount, you'll find this switch device. Multiplexers and demultiplexers have a number of circuits 1:1. Operational temperature extended around 0°C~70°C TA. A total of 8 terminations have been recorded. A high-quality output is provided by the electrical component's 1 channels. When a voltage supply of 5V is used, the electronic component should be turned on and run. An electrical component like this is included in the 8 series. SPST - NO switching circuits are used in these analog switch ics. 2 circuits are used in this analogue multiplexer. MAX323 can be used to search for analog multiplexer variants. There is 60Ohm internal resistance in this digital multiplexer. The datasheets for the 8 pins explain the functions. This switch device is a typical Multiplexer or Switches. Multiplexers should not be powered above 16V in normal situations. An effective Single supply digital multiplexer. The lowest voltage the electronic part should receive is 2.7V. 1μA current would be enough for this multiplexer to operate. The voltage required by this switch device is 2.7V~16V, draining from a single voltage supply. It may damage the digital multiplexer if the voltage is higher than 100pA. The outputs of this digital multiplexer are SEPARATE OUTPUT in number. This electronic component presents a Drain to Source resistance of 33mOhm.
MAX323CSA+ Features
1 Channels
Switch Circuit: SPST - NO
1μA Supply Current
Drain-to-Source resistance: 33mOhm
MAX323CSA+ Applications
There are a lot of Maxim Integrated MAX323CSA+ Analog Switches & Multiplexers ICs applications.
- Digital access cross connects
- Remote Powered Equipment
- Automatic test equipment
- Battery Powered Systems
- Sample hold systems
- Fiber to the Home
- Cable PC
- Sample-and-hold systems
- High-Voltage
- Intelligent PBX
