MAX323ESA+
| Parameters | |
|---|---|
| Factory Lead Time | 1 Week |
| Contact Plating | Tin |
| Mount | Surface Mount |
| Mounting Type | Surface Mount |
| Package / Case | 8-SOIC (0.154, 3.90mm Width) |
| Number of Pins | 8 |
| Operating Temperature | -40°C~85°C TA |
| Packaging | Tube |
| Published | 1998 |
| JESD-609 Code | e3 |
| Pbfree Code | yes |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Number of Terminations | 8 |
| ECCN Code | EAR99 |
| Resistance | 60Ohm |
| Subcategory | Multiplexer or Switches |
| Max Power Dissipation | 471mW |
| Technology | CMOS |
| Terminal Position | DUAL |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | 260 |
| Number of Functions | 2 |
| Supply Voltage | 5V |
| Time@Peak Reflow Temperature-Max (s) | 30 |
| Base Part Number | MAX323 |
| Pin Count | 8 |
| Polarity | Non-Inverting |
| Power Supplies | 3.3/5V |
| Number of Channels | 1 |
| Number of Circuits | 2 |
| Max Supply Voltage | 16V |
| Min Supply Voltage | 2.7V |
| Operating Supply Current | 1μA |
| Nominal Supply Current | 100pA |
| Max Supply Current | 100pA |
| Throw Configuration | SPST |
| Turn On Delay Time | 150 ns |
| Supply Type | Single |
| Turn-Off Delay Time | 100 ns |
| On-State Resistance (Max) | 60Ohm |
| High Level Output Current | 30mA |
| Multiplexer/Demultiplexer Circuit | 1:1 |
| Off-state Isolation-Nom | 72 dB |
| Channel Capacitance (CS(off), CD(off)) | 9pF 9pF |
| On-state Resistance Match-Nom | 0.8Ohm |
| Switch Circuit | SPST - NO |
| Switch Time (Ton, Toff) (Max) | 150ns, 100ns |
| Charge Injection | 1pC |
| Channel-to-Channel Matching (ΔRon) | 800m Ω |
| Crosstalk | -85dB @ 1MHz |
| Switching | BREAK-BEFORE-MAKE |
| Voltage - Supply, Single (V+) | 2.7V~16V |
| Normal Position | NO |
| Height | 1.5mm |
| Length | 5mm |
| Width | 4mm |
| Radiation Hardening | No |
| REACH SVHC | Unknown |
| RoHS Status | ROHS3 Compliant |
| Lead Free | Lead Free |
MAX323ESA+ Overview
The electronic part can be shipped overseas conveniently because it is packaged in 8-SOIC (0.154, 3.90mm Width). High reliability is ensured by the advanced packaging method Tube. In Surface Mount, you'll find this switch device. Multiplexers and demultiplexers have the same number of circuits 1:1. Operation at a temperature around -40°C~85°C TA. In total, 8 terminations have occurred. A 1 channel electronic part produces high-quality output. If the voltage supply is 5V volts, the electrical component should be turned on and run. This electronic part can be found in the 8 series. SPST - NO switching circuits are used in these analog switch ics. A total of 2 circuits make up this switch device. Try searching for MAX323 variants of the analog switch ic. Analog switches have 60Ohm internal resistance. Datasheets for 8 pin functions are available upon request. This switch device is a typical Multiplexer or Switches. It is generally not recommended to supply a voltage higher than 16V to the switch device in normal circumstances. Analog switch ics with Single supply type are cost-effective. 2.7V should be the lowest voltage fed to the electronic component. 1μA current would be enough for this multiplexer to operate. Draining from a single voltage supply, this analog switch requires a voltage of 2.7V~16V. A voltage higher than 100pA may cause damage to the switch multiplexer.
MAX323ESA+ Features
1 Channels
Switch Circuit: SPST - NO
1μA Supply Current
MAX323ESA+ Applications
There are a lot of Maxim Integrated MAX323ESA+ Analog Switches & Multiplexers ICs applications.
- Automotive applications
- Modems
- Public switching systems
- Wireless Local Loop
- Relay Replacement
- Cable Telephony – NIU, Set-Top Box, Home Side Box
- DVD-R
- Audio and video switching
- Video switching
- Communication systems
