MAX327CSE
| Parameters | |
|---|---|
| Mount | Surface Mount |
| Mounting Type | Surface Mount |
| Package / Case | 16-SOIC (0.154, 3.90mm Width) |
| Number of Pins | 16 |
| Operating Temperature | 0°C~70°C TA |
| Packaging | Tube |
| Published | 1996 |
| JESD-609 Code | e3 |
| Pbfree Code | yes |
| Part Status | Obsolete |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Number of Terminations | 16 |
| ECCN Code | EAR99 |
| Resistance | 3.5kOhm |
| Terminal Finish | Tin (Sn) |
| Subcategory | Multiplexer or Switches |
| Max Power Dissipation | 400mW |
| Technology | CMOS |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | 260 |
| Number of Functions | 4 |
| Supply Voltage | 15V |
| Terminal Pitch | 1.27mm |
| Time@Peak Reflow Temperature-Max (s) | 30 |
| Base Part Number | MAX327 |
| Output | SEPARATE OUTPUT |
| Pin Count | 16 |
| Number of Channels | 1 |
| Number of Circuits | 4 |
| Max Supply Voltage | 18V |
| Min Supply Voltage | 5V |
| Nominal Supply Current | 90μA |
| Max Supply Current | 250μA |
| Throw Configuration | SPST |
| Turn On Delay Time | 1 μs |
| Voltage - Supply, Single/Dual (±) | 10V~30V ±5V~18V |
| Supply Type | Dual, Single |
| Neg Supply Voltage-Nom (Vsup) | -15V |
| Turn-Off Delay Time | 500 ns |
| Max Dual Supply Voltage | 18V |
| On-State Resistance (Max) | 3.5kOhm |
| Min Dual Supply Voltage | 4.5V |
| Multiplexer/Demultiplexer Circuit | 1:1 |
| Off-state Isolation-Nom | 70 dB |
| Current - Leakage (IS(off)) (Max) | 10pA |
| Channel Capacitance (CS(off), CD(off)) | 1.7pF 1.7pF |
| On-state Resistance Match-Nom | 75Ohm |
| Switch Circuit | SPST - NO |
| Switch Time (Ton, Toff) (Max) | 1μs, 500ns |
| Charge Injection | 2pC |
| Channel-to-Channel Matching (ΔRon) | 175 Ω |
| Crosstalk | -90dB @ 100kHz |
| Switching | BREAK-BEFORE-MAKE |
| Switch-on Time-Max | 1000ns |
| Normal Position | NO |
| Height | 1.5mm |
| Length | 10mm |
| Width | 4mm |
| Radiation Hardening | No |
| RoHS Status | Non-RoHS Compliant |
| Lead Free | Contains Lead |
MAX327CSE Overview
Shipping overseas is convenient due to the electrical component's packing in 16-SOIC (0.154, 3.90mm Width). High reliability is ensured by the advanced packaging method Tube. Surface Mount is where this multiplexer is located. 1:1 is the ratio between multiplexers and demultiplexers. An extended operating temperature of 0°C~70°C TA degrees Celsius. In total, there are 16 terminations. High-quality output is provided by the electronic component's 1 channels. If the voltage supply is 15V volts, the electrical component should be turned on and run. Electronic part bodies are injected with 16 pins. Multiplexers built on a SPST - NO switching circuit are built. It consists of 4 circuits. Search with MAX327 if you are looking for analog multiplexer variants. Analog switches have 3.5kOhm internal resistance. To find out what the 16 pins do, please refer to the datasheets. This switch device is a typical Multiplexer or Switches. A voltage higher than 18V should not normally be supplied to the switches. Analogue multiplexer with a Dual, Single supply type that is cost-effective. 5V is the lowest voltage the electrical component should receive. The analogue multiplexer may be damaged if voltage is greater than 250μA. If put voltage greater than 18V on the multiplexer, damage may be caused to the device. With dual power supplies, you should attach at least 4.5V. A total of SEPARATE OUTPUT outputs are available on this analog switch ic.
MAX327CSE Features
1 Channels
Switch Circuit: SPST - NO
MAX327CSE Applications
There are a lot of Maxim Integrated MAX327CSE Analog Switches & Multiplexers ICs applications.
- Battery-powered systems
- PCMCIA cards
- Cable PC
- Residential Gateways, Home Gateway/Router
- Data switching
- Short/Medium Loop: approximately 2000 ft. of 26 AWG and 5 REN loads
- Public switching systems
- Digital access cross connects
- Cable Telephony – NIU, Set-Top Box, Home Side Box
- E1 Network Equipment
