MAX333CAP+
| Parameters | |
|---|---|
| Mount | Surface Mount |
| Mounting Type | Surface Mount |
| Package / Case | 20-SSOP (0.209, 5.30mm Width) |
| Number of Pins | 20 |
| Operating Temperature | 0°C~70°C TA |
| Packaging | Tube |
| Published | 1995 |
| Part Status | Obsolete |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Resistance | 35Ohm |
| Base Part Number | MAX333 |
| Operating Supply Voltage | 20V |
| Number of Circuits | 4 |
| Max Supply Voltage | 30V |
| Min Supply Voltage | 10V |
| Operating Supply Current | 1μA |
| Nominal Supply Current | 50μA |
| Max Supply Current | 50μA |
| Turn On Delay Time | 175 ns |
| Voltage - Supply, Single/Dual (±) | 10V~30V ±5V~18V |
| Supply Type | Dual, Single |
| Turn-Off Delay Time | 145 ns |
| Max Dual Supply Voltage | 18V |
| On-State Resistance (Max) | 250Ohm |
| Min Dual Supply Voltage | 5V |
| Multiplexer/Demultiplexer Circuit | 2:1 |
| Current - Leakage (IS(off)) (Max) | 5nA |
| Channel Capacitance (CS(off), CD(off)) | 5pF |
| Switch Circuit | SPDT |
| Switch Time (Ton, Toff) (Max) | 1μs, 500ns |
| Crosstalk | -78dB @ 1MHz |
| Radiation Hardening | No |
| RoHS Status | ROHS3 Compliant |
MAX333CAP+ Overview
Due to its 20-SSOP (0.209, 5.30mm Width) packaging, the electronic part is convenient for international shipping. Advanced packaging method Tube is used to provide high reliability. This analog switch is mounted in Surface Mount. Multiplexers and demultiplexers have a ratio of 2:1. Around 0°C~70°C TA is the extended operating temperature. Based on SPDT switching circuits, these analog multiplexers work. The circuits in this analogue multiplexer number 4. Using the MAX333 search parameter, you can discover variants of the switch. This digital multiplexer has 35Ohm internal resistance. Datasheets for functions of 20 pins are available. In normalcircumstances, users should not exceed 30V volts for the multiplexer. A analog switch ic that has a cost-effective Dual, Single supply type. There should be 10V voltage fed to the electrical part below 10V. It would be sufficient to run this analogue multiplexer with 1μA current. A voltage higher than 50μA may cause damage to the switch multiplexer. If put voltage greater than 18V on the multiplexer, damage may be caused to the device. The voltage should be at least 5V if you are using dual power supplies. 20V operating voltages are supported by the electronic component.
MAX333CAP+ Features
Switch Circuit: SPDT
1μA Supply Current
MAX333CAP+ Applications
There are a lot of Maxim Integrated MAX333CAP+ Analog Switches & Multiplexers ICs applications.
- Medical systems
- PDAs
- Transmit
- Cable Telephony – NIU, Set-Top Box, Home Side Box
- Automatic test equipment
- Digital cross connects (DSX-1)
- DSLAMs
- Battery Powered Systems
- Battery Powered Instruments
- Cell phones
