MAX335ENG+
| Parameters | |
|---|---|
| Factory Lead Time | 1 Week |
| Mounting Type | Through Hole |
| Package / Case | 24-DIP (0.300, 7.62mm) |
| Surface Mount | NO |
| Operating Temperature | -40°C~85°C TA |
| Packaging | Tube |
| Published | 1996 |
| Pbfree Code | yes |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Number of Terminations | 24 |
| ECCN Code | EAR99 |
| Technology | CMOS |
| Terminal Position | DUAL |
| Peak Reflow Temperature (Cel) | NOT SPECIFIED |
| Number of Functions | 8 |
| Supply Voltage | 15V |
| Terminal Pitch | 2.54mm |
| Time@Peak Reflow Temperature-Max (s) | NOT SPECIFIED |
| Base Part Number | MAX335 |
| Pin Count | 24 |
| JESD-30 Code | R-PDIP-T24 |
| Supply Voltage-Min (Vsup) | 4.5V |
| Number of Channels | 1 |
| Number of Circuits | 8 |
| Neg Supply Voltage-Nom (Vsup) | -15V |
| On-State Resistance (Max) | 150Ohm |
| Multiplexer/Demultiplexer Circuit | 1:1 |
| Off-state Isolation-Nom | 90 dB |
| Neg Supply Voltage-Max (Vsup) | -20V |
| Current - Leakage (IS(off)) (Max) | 1nA |
| Channel Capacitance (CS(off), CD(off)) | 2pF 2pF |
| Switch Circuit | SPST - NO |
| Switch Time (Ton, Toff) (Max) | 400ns, 400ns |
| Crosstalk | -100dB @ 100kHz |
| Switch-on Time-Max | 500ns |
| Switch-off Time-Max | 500ns |
| Neg Supply Voltage-Min (Vsup) | -4.5V |
| Voltage - Supply, Dual (V±) | ±4.5V~20V |
| Length | 31.75mm |
| Width | 15.24mm |
| RoHS Status | ROHS3 Compliant |
MAX335ENG+ Overview
The electronic component is convenient to ship overseas because it is packed in a 24-DIP (0.300, 7.62mm). To ensure high reliability, a new packaging method Tube is used. There is an analog multiplexer mounted in position Through Hole. 1:1 is the number of circuits in the multiplexer and demultiplexer. The operating temperature is extended to around -40°C~85°C TA. Total terminations are 24. By its 1 channels, the electronic component provides high-quality output. When a voltage supply of 15V is used, the electronic component should be turned on and run. 24 pins are injected to the electronic part body. The analog switch ics are built using SPST - NO switching circuits. A total of 8 circuits make up this switch device. Try searching for MAX335 variants of the analog switch ic. To power the multiplexer ics, the voltage must be set at 4.5V.
MAX335ENG+ Features
1 Channels
Switch Circuit: SPST - NO
MAX335ENG+ Applications
There are a lot of Maxim Integrated MAX335ENG+ Analog Switches & Multiplexers ICs applications.
- Microwave transmission systems
- Battery Powered Systems
- Imaging
- Automatic test equipment
- Power routing
- Industrial and process control systems
- Fault Tolerant Systems
- Fiber In The Loop (FITL)
- Public switching systems
- Transmit
