Parameters |
Max Dual Supply Voltage |
20V |
On-State Resistance (Max) |
400Ohm |
Min Dual Supply Voltage |
4.5V |
High Level Output Current |
30mA |
Multiplexer/Demultiplexer Circuit |
8:1 |
Off-state Isolation-Nom |
75 dB |
Current - Leakage (IS(off)) (Max) |
20pA |
Channel Capacitance (CS(off), CD(off)) |
3pF 11pF |
On-state Resistance Match-Nom |
4Ohm |
Switch Time (Ton, Toff) (Max) |
500ns, 500ns |
Charge Injection |
1.5pC |
Channel-to-Channel Matching (ΔRon) |
4 Ω |
Crosstalk |
-92dB @ 100kHz |
Switching |
BREAK-BEFORE-MAKE |
Signal Current-Max |
0.03A |
Height |
1.5mm |
Length |
10mm |
Width |
4mm |
Radiation Hardening |
No |
REACH SVHC |
No SVHC |
RoHS Status |
ROHS3 Compliant |
Lead Free |
Lead Free |
Factory Lead Time |
1 Week |
Contact Plating |
Tin |
Mount |
Surface Mount |
Mounting Type |
Surface Mount |
Package / Case |
16-SOIC (0.154, 3.90mm Width) |
Number of Pins |
16 |
Operating Temperature |
-40°C~85°C TA |
Packaging |
Tube |
Published |
2003 |
JESD-609 Code |
e3 |
Pbfree Code |
yes |
Part Status |
Active |
Moisture Sensitivity Level (MSL) |
1 (Unlimited) |
Number of Terminations |
16 |
ECCN Code |
EAR99 |
Resistance |
400Ohm |
Max Power Dissipation |
696mW |
Technology |
CMOS |
Terminal Form |
GULL WING |
Peak Reflow Temperature (Cel) |
260 |
Number of Functions |
1 |
Supply Voltage |
15V |
Time@Peak Reflow Temperature-Max (s) |
30 |
Base Part Number |
MAX338 |
Pin Count |
16 |
Operating Supply Voltage |
28V |
Number of Channels |
8 |
Number of Circuits |
1 |
Max Supply Voltage |
30V |
Min Supply Voltage |
4.5V |
Operating Supply Current |
1μA |
Nominal Supply Current |
50μA |
Throw Configuration |
DPST |
Propagation Delay |
500 ns |
Turn On Delay Time |
500 ns |
Logic Function |
Multiplexer |
Voltage - Supply, Single/Dual (±) |
4.5V~30V ±4.5V~20V |
Supply Type |
Dual, Single |
Neg Supply Voltage-Nom (Vsup) |
-15V |
Turn-Off Delay Time |
500 ns |
MAX338ESE+ Overview
Packed in 16-SOIC (0.154, 3.90mm Width), the electronic component is convenient for shipping overseas. The advanced packaging method Tube provides high reliability. The multiplexer is located in Surface Mount. 8:1 is the ratio between multiplexers and demultiplexers. Operating temperature extended to -40°C~85°C TA. In total, 16 terminations have occurred. By its 8 channels, the electronic component provides high-quality output. If the voltage supply is 15V volts, the electrical component should be turned on and run. Into the electrical component body are injected 16 pins. 1 circuits are used in this analogue multiplexer. Try searching for the analog switch ic with MAX338 if you are looking for variants. Analog switches have 400Ohm internal resistance. Datasheets for functions of 16 pins are available. In a normalsituation, users should not supply the switches with voltage higher than 30V. The analog switch ic is of the Dual, Single supply type and is cost-effective. A low voltage of 4.5V should be applied to the electronic component. The analogue multiplexer could operate on 1μA current. For this switch device, it is feasible to have two supplies. However, the voltage should not exceed 20V. In the case of dual power supplies, you should connect at least 4.5V. A voltage of 28V can be used to operate the electronic component.
MAX338ESE+ Features
8 Channels
1μA Supply Current
MAX338ESE+ Applications
There are a lot of Maxim Integrated MAX338ESE+ Analog Switches & Multiplexers ICs applications.
- DSLAMs
- HDTV
- Cell phones
- Transmit
- Medical Instrumentation
- T1/E1 Terminals
- SONET
- Channel Banks
- Audio and video routing
- Central office