MAX349CAP
| Parameters | |
|---|---|
| Mounting Type | Surface Mount |
| Package / Case | 20-SSOP (0.209, 5.30mm Width) |
| Surface Mount | YES |
| Operating Temperature | 0°C~70°C TA |
| Packaging | Tube |
| Published | 1999 |
| JESD-609 Code | e0 |
| Pbfree Code | no |
| Part Status | Obsolete |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Number of Terminations | 20 |
| ECCN Code | EAR99 |
| Subcategory | Multiplexer or Switches |
| Technology | CMOS |
| Terminal Position | DUAL |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | 245 |
| Number of Functions | 1 |
| Supply Voltage | 5V |
| Terminal Pitch | 0.65mm |
| Reach Compliance Code | not_compliant |
| Time@Peak Reflow Temperature-Max (s) | NOT SPECIFIED |
| Base Part Number | MAX349 |
| Pin Count | 20 |
| JESD-30 Code | R-PDSO-G20 |
| Qualification Status | Not Qualified |
| Power Supplies | 3/5/+-5V |
| Number of Channels | 8 |
| Number of Circuits | 1 |
| Analog IC - Other Type | SINGLE-ENDED MULTIPLEXER |
| Voltage - Supply, Single/Dual (±) | 2.7V~16V ±2.7V~8V |
| Supply Current-Max (Isup) | 0.03mA |
| Neg Supply Voltage-Nom (Vsup) | -5V |
| On-State Resistance (Max) | 100Ohm |
| Multiplexer/Demultiplexer Circuit | 8:1 |
| Current - Leakage (IS(off)) (Max) | 100pA |
| Channel Capacitance (CS(off), CD(off)) | 2pF 2pF |
| On-state Resistance Match-Nom | 16Ohm |
| Switch Time (Ton, Toff) (Max) | 275ns, 150ns |
| Charge Injection | 1pC |
| Channel-to-Channel Matching (ΔRon) | 16 Ω (Max) |
| Crosstalk | -90dB @ 100kHz |
| Switching | BREAK-BEFORE-MAKE |
| Switch-on Time-Max | 400ns |
| Switch-off Time-Max | 300ns |
| Signal Current-Max | 0.03A |
| Length | 7.2mm |
| Width | 5.29mm |
| RoHS Status | Non-RoHS Compliant |
| Lead Free | Contains Lead |
MAX349CAP Overview
The electronic component is convenient to ship overseas because it is packed in a 20-SSOP (0.209, 5.30mm Width). Advanced packaging method Tube is used to provide high reliability. Surface Mount is where this multiplexer is located. The ratio between the number of multiplexer and demultiplexer circuits is 8:1. An extended operating temperature of 0°C~70°C TA degrees Celsius. 20 terminations have been made so far. Due to its 8 channels, the electrical component produces high-quality output. With a 5V voltage supply, the electrical component should be turned on and run. It is part of the design of the 20 series that this electronic component is included. The circuits in this analogue multiplexer number 1. Try searching with MAX349 if you're looking for variants. This switch device is a typical Multiplexer or Switches. An analog IC with the number SINGLE-ENDED MULTIPLEXER is integrated into this board.
MAX349CAP Features
8 Channels
MAX349CAP Applications
There are a lot of Maxim Integrated MAX349CAP Analog Switches & Multiplexers ICs applications.
- Residential Gateways, Home Gateway/Router
- Microprocessor controlled systems
- PDAs
- E1 Network Equipment
- New designs requiring multiplexer functions
- RGB switches
- Avionics
- Intelligent PBX
- Communications systems
- 65 V DACs
