MAX350CAP
| Parameters | |
|---|---|
| Contact Plating | Tin |
| Mount | Surface Mount |
| Mounting Type | Surface Mount |
| Package / Case | 20-SSOP (0.209, 5.30mm Width) |
| Number of Pins | 20 |
| Operating Temperature | 0°C~70°C TA |
| Packaging | Tube |
| Published | 1999 |
| JESD-609 Code | e0 |
| Pbfree Code | no |
| Part Status | Obsolete |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Number of Terminations | 20 |
| ECCN Code | EAR99 |
| Resistance | 100Ohm |
| Max Power Dissipation | 640mW |
| Technology | CMOS |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | 245 |
| Number of Functions | 1 |
| Supply Voltage | 5V |
| Terminal Pitch | 0.65mm |
| Base Part Number | MAX350 |
| Pin Count | 20 |
| Operating Supply Voltage | 15V |
| Number of Channels | 4 |
| Number of Circuits | 2 |
| Max Supply Voltage | 16V |
| Min Supply Voltage | 2.7V |
| Operating Supply Current | 1μA |
| Turn On Delay Time | 600 ns |
| Logic Function | Multiplexer |
| Voltage - Supply, Single/Dual (±) | 2.7V~16V ±2.7V~8V |
| Supply Type | Dual, Single |
| Supply Current-Max (Isup) | 0.03mA |
| Neg Supply Voltage-Nom (Vsup) | -5V |
| Turn-Off Delay Time | 300 ns |
| Max Dual Supply Voltage | 8V |
| On-State Resistance (Max) | 100Ohm |
| Min Dual Supply Voltage | 3V |
| High Level Output Current | 30mA |
| Dual Supply Voltage | 5V |
| Multiplexer/Demultiplexer Circuit | 4:1 |
| Current - Leakage (IS(off)) (Max) | 100pA |
| Channel Capacitance (CS(off), CD(off)) | 2pF 2pF |
| On-state Resistance Match-Nom | 16Ohm |
| Switch Circuit | SP4T |
| Switch Time (Ton, Toff) (Max) | 275ns, 150ns |
| Charge Injection | 1pC |
| Channel-to-Channel Matching (ΔRon) | 16 Ω (Max) |
| Crosstalk | -90dB @ 100kHz |
| Switching | BREAK-BEFORE-MAKE |
| Switch-on Time-Max | 400ns |
| Signal Current-Max | 0.03A |
| Height Seated (Max) | 1.99mm |
| Radiation Hardening | No |
| REACH SVHC | Unknown |
| RoHS Status | Non-RoHS Compliant |
MAX350CAP Overview
As the electronic part is packed in 20-SSOP (0.209, 5.30mm Width), international shipping is convenient. High reliability is provided by advanced packaging method Tube. In Surface Mount, you'll find this switch device. Multiplexers and demultiplexers have the same number of circuits 4:1. An extended operating temperature of 0°C~70°C TA degrees Celsius. In total, 20 terminations have occurred. This electronic part offers high-quality output due to its 4 channels. In the case of a voltage supply of 5V volts, the electrical part can be powered up and run. An electrical component like this is included in the 20 series. Unlike digital switches, these are based on SP4T switching circuits. The circuits in this analogue multiplexer number 2. If you are looking for variants of the digital switch, trying search with MAX350. A 100Ohm internal resistance characterizes this multiplexer. To find out what the 20 pins do, please refer to the datasheets. In a normalsituation, users should not supply the switches with voltage higher than 16V. A cost-effective Dual, Single supply type analogue multiplexer. A low voltage of 2.7V should be applied to the electronic component. For this multiplexer to operate, 1μA current would be sufficient. For this multiplexer, dual supply voltage is feasible, but it should not exceed 8V. In the case of dual power supplies, you should connect at least 3V. 15V operating voltages are supported by the electronic component.
MAX350CAP Features
4 Channels
Switch Circuit: SP4T
1μA Supply Current
MAX350CAP Applications
There are a lot of Maxim Integrated MAX350CAP Analog Switches & Multiplexers ICs applications.
- Public switching systems
- Channelized and Unchannelized DS3 applications
- Residential Gateways, Home Gateway/Router
- Channel Banks
- Digital access cross connects
- SDH/SONET multiplexers
- Short/Medium Loop: approximately 2000 ft. of 26 AWG and 5 REN loads
- Video signal routing
- New designs requiring multiplexer functions
- Audio signal routing
