MAX351CPE
| Parameters | |
|---|---|
| Neg Supply Voltage-Nom (Vsup) | -15V |
| On-State Resistance (Max) | 35Ohm |
| Multiplexer/Demultiplexer Circuit | 1:1 |
| Off-state Isolation-Nom | 68 dB |
| Current - Leakage (IS(off)) (Max) | 250pA |
| Channel Capacitance (CS(off), CD(off)) | 9pF 9pF |
| On-state Resistance Match-Nom | 2Ohm |
| Switch Circuit | SPST - NC |
| Switch Time (Ton, Toff) (Max) | 175ns, 145ns |
| Charge Injection | 5pC |
| Channel-to-Channel Matching (ΔRon) | 2 Ω (Max) |
| Crosstalk | -85dB @ 1MHz |
| Switching | BREAK-BEFORE-MAKE |
| Switch-on Time-Max | 175ns |
| Normal Position | NC |
| Length | 19.175mm |
| Width | 7.62mm |
| RoHS Status | Non-RoHS Compliant |
| Mounting Type | Through Hole |
| Package / Case | 16-DIP (0.300, 7.62mm) |
| Surface Mount | NO |
| Operating Temperature | 0°C~70°C TA |
| Packaging | Tube |
| Published | 2002 |
| JESD-609 Code | e0 |
| Pbfree Code | no |
| Part Status | Obsolete |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Number of Terminations | 16 |
| ECCN Code | EAR99 |
| Terminal Finish | Tin/Lead (Sn85Pb15) |
| Subcategory | Multiplexer or Switches |
| Technology | CMOS |
| Terminal Position | DUAL |
| Peak Reflow Temperature (Cel) | 245 |
| Number of Functions | 4 |
| Supply Voltage | 15V |
| Reach Compliance Code | not_compliant |
| Time@Peak Reflow Temperature-Max (s) | NOT SPECIFIED |
| Base Part Number | MAX351 |
| Output | SEPARATE OUTPUT |
| Pin Count | 16 |
| JESD-30 Code | R-PDIP-T16 |
| Qualification Status | Not Qualified |
| Power Supplies | 512/+-15V |
| Number of Channels | 1 |
| Number of Circuits | 4 |
| Voltage - Supply, Single/Dual (±) | 10V~30V ±4.5V~20V |
MAX351CPE Overview
Due to its 16-DIP (0.300, 7.62mm) packaging, the electronic part is convenient for international shipping. To ensure high reliability, a new packaging method Tube is used. In Through Hole, you'll find this switch device. 1:1 is the ratio between multiplexers and demultiplexers. Increasing operating temperature to around 0°C~70°C TA. 16 terminations have been made so far. A 1 channel electronic part produces high-quality output. When the electronic component is given a voltage of 15V, it should be turned on and run. This electrical component is included in the 16 series of products. Unlike digital switches, these are based on SPST - NC switching circuits. A total of 4 circuits make up this switch device. Try searching for the analog switch ic with MAX351 if you are looking for variants. In this analog multiplexer, the value is Multiplexer or Switches. The outputs of this digital multiplexer are SEPARATE OUTPUT in number.
MAX351CPE Features
1 Channels
Switch Circuit: SPST - NC
MAX351CPE Applications
There are a lot of Maxim Integrated MAX351CPE Analog Switches & Multiplexers ICs applications.
- Residential Gateways, Home Gateway/Router
- Imaging
- DSUs
- Cell phones
- Automotive applications
- Communications systems
- Signal routing between systems
- Battery Powered Systems
- Cable Modem
- Channel Banks
