MAX354EWE+
| Parameters | |
|---|---|
| Terminal Finish | Matte Tin (Sn) |
| Max Power Dissipation | 762mW |
| Technology | CMOS |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | 260 |
| Number of Functions | 1 |
| Supply Voltage | 15V |
| Base Part Number | MAX354 |
| Pin Count | 16 |
| Operating Supply Voltage | 28V |
| Number of Channels | 8 |
| Interface | Logic |
| Number of Circuits | 1 |
| Max Supply Voltage | 36V |
| Min Supply Voltage | 4.5V |
| Operating Supply Current | 300μA |
| Nominal Supply Current | 300μA |
| Throw Configuration | DPST |
| Propagation Delay | 250 ns |
| Turn On Delay Time | 250 ns |
| Logic Function | Multiplexer |
| Voltage - Supply, Single/Dual (±) | 4.5V~36V ±4.5V~18V |
| Supply Type | Dual, Single |
| Supply Current-Max (Isup) | 0.5mA |
| Neg Supply Voltage-Nom (Vsup) | -15V |
| Turn-Off Delay Time | 200 ns |
| Max Dual Supply Voltage | 18V |
| On-State Resistance (Max) | 350Ohm |
| Min Dual Supply Voltage | 4.5V |
| Multiplexer/Demultiplexer Circuit | 8:1 |
| Off-state Isolation-Nom | 100 dB |
| Current - Leakage (IS(off)) (Max) | 500pA |
| Channel Capacitance (CS(off), CD(off)) | 1.6pF 11pF |
| On-state Resistance Match-Nom | 7Ohm |
| Switch Time (Ton, Toff) (Max) | 250ns, 200ns |
| Charge Injection | 80pC |
| Channel-to-Channel Matching (ΔRon) | 7 Ω |
| Crosstalk | -92dB @ 100kHz |
| Switching | BREAK-BEFORE-MAKE |
| Switch-on Time-Max | 400ns |
| Switch-off Time-Max | 300ns |
| Signal Current-Max | 0.03A |
| Height | 2.35mm |
| Length | 10.5mm |
| Width | 7.6mm |
| Radiation Hardening | No |
| RoHS Status | ROHS3 Compliant |
| Lead Free | Lead Free |
| Factory Lead Time | 1 Week |
| Mount | Surface Mount |
| Mounting Type | Surface Mount |
| Package / Case | 16-SOIC (0.295, 7.50mm Width) |
| Number of Pins | 16 |
| Operating Temperature | -40°C~85°C TA |
| Packaging | Tube |
| Published | 1996 |
| JESD-609 Code | e3 |
| Pbfree Code | yes |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Number of Terminations | 16 |
| Termination | SMD/SMT |
| ECCN Code | EAR99 |
| Resistance | 350Ohm |
MAX354EWE+ Overview
The electrical component comes in 16-SOIC (0.295, 7.50mm Width) packaging, which makes it convenient to ship overseas. High reliability is ensured by the advanced packaging method Tube. Mounted in Surface Mount is this multiplexer. Multiplexers and demultiplexers have the same number of circuits 8:1. Temperatures around -40°C~85°C TA are extended for operation. Totally, there are 16 terminations. This electronic part offers high-quality output due to its 8 channels. An 15V voltage supply should allow the electrical part to be turned on and run. An electrical component of this type can be found in the 16 series. A total of 1 circuits make up this switch device. If you are looking for variants of the digital switch, trying search with MAX354. Internally, this switch multiplexer has a resistance of 350Ohm. To find out what the 16 pins do, please refer to the datasheets. In a normalsituation, users should not supply the switches with voltage higher than 36V. A analog switch ic that has a cost-effective Dual, Single supply type. In order for the electronic part to function properly, the lowest voltage should be 4.5V. The analogue multiplexer could operate on 300μA current. Despite this switch's dual supply capability, its voltage should not exceed 18V. The voltage should be at least 4.5V if you are using dual power supplies. The electrical part can be operated at 28V voltage levels.
MAX354EWE+ Features
8 Channels
300μA Supply Current
MAX354EWE+ Applications
There are a lot of Maxim Integrated MAX354EWE+ Analog Switches & Multiplexers ICs applications.
- Audio/video switches
- Data Acquisition Systems
- Precision test equipment
- T1/E1 Terminals
- CSU
- E1 Network Equipment
- Short/Medium Loop: approximately 2000 ft. of 26 AWG and 5 REN loads
- Isolation
- Audio and video signal routing
- Cable PC
