banner_page

MAX397CPI+

DUAL Analog Switches BREAK-BEFORE-MAKE 28 Pins 5V DIP


  • Manufacturer: Maxim Integrated
  • Nocochips NO: 503-MAX397CPI+
  • Package: DIP
  • Datasheet: PDF
  • Stock: 554
  • Description: DUAL Analog Switches BREAK-BEFORE-MAKE 28 Pins 5V DIP(Kg)

Details

Tags

Parameters
Package / Case DIP
Surface Mount NO
Number of Pins 28
Packaging Tube
Published 2016
JESD-609 Code e3
Pbfree Code yes
Part Status Active
Moisture Sensitivity Level (MSL) 1 (Unlimited)
Number of Terminations 28
ECCN Code EAR99
Resistance 100Ohm
Terminal Finish Tin (Sn)
Max Operating Temperature 70°C
Min Operating Temperature 0°C
Subcategory Multiplexer or Switches
Technology CMOS
Terminal Position DUAL
Terminal Form THROUGH-HOLE
Peak Reflow Temperature (Cel) 260
Number of Functions 1
Supply Voltage 5V
Pin Count 28
Temperature Grade COMMERCIAL
Number of Channels 8
Number of Circuits 2
Max Supply Voltage 16V
Min Supply Voltage 2.7V
Analog IC - Other Type DIFFERENTIAL MULTIPLEXER
Supply Current-Max (Isup) 0.001mA
Neg Supply Voltage-Nom (Vsup) -5V
Max Dual Supply Voltage 8V
Min Dual Supply Voltage 3V
Off-state Isolation-Nom 75 dB
On-state Resistance Match-Nom 1.8Ohm
Switching BREAK-BEFORE-MAKE
Signal Current-Max 0.03A
Height Seated (Max) 5.08mm
Length 36.83mm
Radiation Hardening No
RoHS Status ROHS3 Compliant

MAX397CPI+ Overview


The electrical component comes in DIP packaging, which makes it convenient to ship overseas. High reliability is provided by advanced packaging method Tube. In total, there have been 28 terminations. Due to its 8 channels, the electrical component produces high-quality output. An 5V voltage supply should allow the electrical part to be turned on and run. A key feature of the 28 series is the inclusion of this electronic part as part of its design. 2 circuits are used in this analogue multiplexer. In this multiplexer, the internal resistance is 100Ohm. Datasheets for 28 pin functions are available upon request. A analogue multiplexer of this type is a Multiplexer or Switches. In a normalsituation, users should not supply the switches with voltage higher than 16V. 2.7V is the lowest voltage that should be fed to the electronic electronic part. For this multiplexer, dual supply voltage is feasible, but it should not exceed 8V. When using dual power supplies, you should attach at least 3V. A DIFFERENTIAL MULTIPLEXER analog IC is integrated into the board. Temperatures above 70°C should not be used to operate the switches.

MAX397CPI+ Features


8 Channels

MAX397CPI+ Applications


There are a lot of Maxim Integrated MAX397CPI+ Analog Switches & Multiplexers ICs applications.

  • High speed data transmission line cards
  • Signal routing between systems
  • Fiber to the Home
  • Digital access cross connects
  • PDAs
  • Cable PC
  • High reliability control systems
  • SDH/SONET multiplexers
  • Cable Telephony – NIU, Set-Top Box, Home Side Box
  • 65 V DACs

Write a review

Note: HTML is not translated!
    Bad           Good