MAX4073TAUT+T
| Parameters | |
|---|---|
| Factory Lead Time | 1 Week |
| Mounting Type | Surface Mount |
| Package / Case | SOT-23-6 |
| Surface Mount | YES |
| Number of Pins | 6 |
| Operating Temperature | -40°C~125°C |
| Packaging | Tape & Reel (TR) |
| Published | 2008 |
| JESD-609 Code | e3 |
| Pbfree Code | yes |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Number of Terminations | 6 |
| ECCN Code | EAR99 |
| Terminal Finish | Matte Tin (Sn) |
| Technology | BIPOLAR |
| Terminal Position | DUAL |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | 260 |
| Number of Functions | 1 |
| Supply Voltage | 12V |
| Terminal Pitch | 0.95mm |
| Time@Peak Reflow Temperature-Max (s) | 30 |
| Base Part Number | MAX4073 |
| Pin Count | 6 |
| Qualification Status | Not Qualified |
| Supply Voltage-Max (Vsup) | 28V |
| Supply Voltage-Min (Vsup) | 3V |
| Number of Channels | 1 |
| Number of Circuits | 1 |
| Analog IC - Other Type | POWER SUPPLY SUPPORT CIRCUIT |
| Adjustable Threshold | NO |
| Current - Supply | 500μA |
| Amplifier Type | Current Sense |
| Current - Input Bias | 40μA |
| Voltage - Supply, Single/Dual (±) | 3V~28V |
| Bandwidth | 1.8MHz |
| Voltage - Input Offset | 1mV |
| Length | 2.9mm |
| RoHS Status | ROHS3 Compliant |
MAX4073TAUT+T Overview
Packaging for the buffer amplifier is in the form of a SOT-23-6 case. An op amp of this type is a Current Sense-type. There is a Tape & Reel (TR) case that is delivered with the instrumentation amplifiers. There have been a total of 6 terminations over the past year. The pins on this board total to 6 in total. It would be helpful if you could remember that this op amp ic should be powered by an 12V battery. There are 6 pins on this chip. For this electrical component, the recommended mounting type is Surface Mount, which is the most common. With regard to operating temperature, op amp ranges -40°C~125°C. This op amp ic has 1 circuits. As far as the device is concerned, buffer amplifier has 1 channels. In order to ensure optimal performance, an 500μA supply is recommended for this electrical component. There is also another type of analog IC used in this op amp ic that is called a POWER SUPPLY SUPPORT CIRCUIT-type IC.
MAX4073TAUT+T Features
6 Pins
supply voltage of 12V
MAX4073TAUT+T Applications
There are a lot of Maxim Integrated MAX4073TAUT+T Instrumentational OP Amps applications.
- Instrumentation
- Tablets
- Hand-held batteries
- Mobile phone
- Medical imaging
- Large motor controllers
- Inverse/same-phase proportional circuit
- Signal amplification
- MP3
- Laptop
